lkml.org 
[lkml]   [2021]   [Jun]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 1/1] ARM: dts: stm32: Configure qspi's mdma transfer to block for stm32mp151
From
Date
Hi Patrice

On 4/26/21 12:45 PM, patrice.chotard@foss.st.com wrote:
> From: Patrice Chotard <patrice.chotard@foss.st.com>
>
> Configure qspi's mdma from buffer transfer (max 128 bytes) to
> block transfer (max 64K bytes).
>
> mtd_speedtest shows that write throughtput increases :
> - from 734 to 782 KiB/s (~6.5%) with s25fl512s SPI-NOR.
> - from 4848 to 5319 KiB/s (~9.72%) with Micron SPI-NAND.
>
> Signed-off-by: Christophe Kerello <christophe.kerello@foss.st.com>
> Signed-off-by: Patrice Chotard <patrice.chotard@foss.st.com>
> ---
> arch/arm/boot/dts/stm32mp151.dtsi | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/arch/arm/boot/dts/stm32mp151.dtsi b/arch/arm/boot/dts/stm32mp151.dtsi
> index 4b8031782555..cb326c1e12bc 100644
> --- a/arch/arm/boot/dts/stm32mp151.dtsi
> +++ b/arch/arm/boot/dts/stm32mp151.dtsi
> @@ -1358,8 +1358,8 @@
> reg = <0x58003000 0x1000>, <0x70000000 0x10000000>;
> reg-names = "qspi", "qspi_mm";
> interrupts = <GIC_SPI 92 IRQ_TYPE_LEVEL_HIGH>;
> - dmas = <&mdma1 22 0x2 0x100002 0x0 0x0>,
> - <&mdma1 22 0x2 0x100008 0x0 0x0>;
> + dmas = <&mdma1 22 0x2 0x10100002 0x0 0x0>,
> + <&mdma1 22 0x2 0x10100008 0x0 0x0>;
> dma-names = "tx", "rx";
> clocks = <&rcc QSPI_K>;
> resets = <&rcc QSPI_R>;
>

Applied on stm32-next.

Thanks.
Alex

\
 
 \ /
  Last update: 2021-06-01 09:26    [W:0.032 / U:0.288 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site