Messages in this thread Patch in this message | | | From | Chen-Yu Tsai <> | Subject | [PATCH 2/4] arm64: dts: rockchip: rk3328: Enable USB3 for ROC-RK3328-CC | Date | Tue, 4 May 2021 16:36:14 +0800 |
| |
From: Chen-Yu Tsai <wens@csie.org>
Enable USB3 nodes for the ROC-RK3328-CC board.
The separate power regulator is not added as it is controlled by the same GPIO line as the existing VBUS regulators, so it is already enabled. Also there is no port representation to tie the regulator to.
Signed-off-by: Chen-Yu Tsai <wens@csie.org> --- arch/arm64/boot/dts/rockchip/rk3328-roc-cc.dts | 5 +++++ 1 file changed, 5 insertions(+)
diff --git a/arch/arm64/boot/dts/rockchip/rk3328-roc-cc.dts b/arch/arm64/boot/dts/rockchip/rk3328-roc-cc.dts index a05732b59f38..bdf0ca07eae9 100644 --- a/arch/arm64/boot/dts/rockchip/rk3328-roc-cc.dts +++ b/arch/arm64/boot/dts/rockchip/rk3328-roc-cc.dts @@ -363,6 +363,11 @@ &usb20_otg { status = "okay"; }; +&usbdrd3 { + dr_mode = "host"; + status = "okay"; +}; + &usb_host0_ehci { status = "okay"; }; -- 2.31.1
| |