lkml.org 
[lkml]   [2021]   [May]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH net-next v6 14/25] net: dsa: qca8k: add support for switch rev
Date
qca8k internal phy driver require some special debug value to be set
based on the switch revision. Rework the switch id read function to
also read the chip revision.

Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
---
drivers/net/dsa/qca8k.c | 53 ++++++++++++++++++++++++++---------------
drivers/net/dsa/qca8k.h | 7 ++++--
2 files changed, 39 insertions(+), 21 deletions(-)

diff --git a/drivers/net/dsa/qca8k.c b/drivers/net/dsa/qca8k.c
index 10e3e1ca7e95..35ff4cf08786 100644
--- a/drivers/net/dsa/qca8k.c
+++ b/drivers/net/dsa/qca8k.c
@@ -1579,12 +1579,40 @@ static const struct dsa_switch_ops qca8k_switch_ops = {
.phylink_mac_link_up = qca8k_phylink_mac_link_up,
};

+static int qca8k_read_switch_id(struct qca8k_priv *priv)
+{
+ const struct qca8k_match_data *data;
+ u32 val;
+ u8 id;
+
+ /* get the switches ID from the compatible */
+ data = of_device_get_match_data(priv->dev);
+ if (!data)
+ return -ENODEV;
+
+ val = qca8k_read(priv, QCA8K_REG_MASK_CTRL);
+ if (val < 0)
+ return -ENODEV;
+
+ id = QCA8K_MASK_CTRL_DEVICE_ID(val & QCA8K_MASK_CTRL_DEVICE_ID_MASK);
+ if (id != data->id) {
+ dev_err(priv->dev, "Switch id detected %x but expected %x", id, data->id);
+ return -ENODEV;
+ }
+
+ priv->switch_id = id;
+
+ /* Save revision to communicate to the internal PHY driver */
+ priv->switch_revision = (val & QCA8K_MASK_CTRL_REV_ID_MASK);
+
+ return 0;
+}
+
static int
qca8k_sw_probe(struct mdio_device *mdiodev)
{
- const struct qca8k_match_data *data;
struct qca8k_priv *priv;
- u32 id;
+ int ret;

/* allocate the private data struct so that we can probe the switches
* ID register
@@ -1610,24 +1638,11 @@ qca8k_sw_probe(struct mdio_device *mdiodev)
gpiod_set_value_cansleep(priv->reset_gpio, 0);
}

- /* get the switches ID from the compatible */
- data = of_device_get_match_data(&mdiodev->dev);
- if (!data)
- return -ENODEV;
-
- /* read the switches ID register */
- id = qca8k_read(priv, QCA8K_REG_MASK_CTRL);
- if (id < 0)
- return id;
-
- id >>= QCA8K_MASK_CTRL_ID_S;
- id &= QCA8K_MASK_CTRL_ID_M;
- if (id != data->id) {
- dev_err(&mdiodev->dev, "Switch id detected %x but expected %x", id, data->id);
- return -ENODEV;
- }
+ /* Check the detected switch id */
+ ret = qca8k_read_switch_id(priv);
+ if (ret)
+ return ret;

- priv->switch_id = id;
priv->ds = devm_kzalloc(&mdiodev->dev, sizeof(*priv->ds), GFP_KERNEL);
if (!priv->ds)
return -ENOMEM;
diff --git a/drivers/net/dsa/qca8k.h b/drivers/net/dsa/qca8k.h
index eceeacfe2c5d..338277978ec0 100644
--- a/drivers/net/dsa/qca8k.h
+++ b/drivers/net/dsa/qca8k.h
@@ -30,8 +30,10 @@

/* Global control registers */
#define QCA8K_REG_MASK_CTRL 0x000
-#define QCA8K_MASK_CTRL_ID_M 0xff
-#define QCA8K_MASK_CTRL_ID_S 8
+#define QCA8K_MASK_CTRL_REV_ID_MASK GENMASK(7, 0)
+#define QCA8K_MASK_CTRL_REV_ID(x) ((x) >> 0)
+#define QCA8K_MASK_CTRL_DEVICE_ID_MASK GENMASK(15, 8)
+#define QCA8K_MASK_CTRL_DEVICE_ID(x) ((x) >> 8)
#define QCA8K_REG_PORT0_PAD_CTRL 0x004
#define QCA8K_REG_PORT5_PAD_CTRL 0x008
#define QCA8K_REG_PORT6_PAD_CTRL 0x00c
@@ -251,6 +253,7 @@ struct qca8k_match_data {

struct qca8k_priv {
u8 switch_id;
+ u8 switch_revision;
struct regmap *regmap;
struct mii_bus *bus;
struct ar8xxx_port_status port_sts[QCA8K_NUM_PORTS];
--
2.30.2
\
 
 \ /
  Last update: 2021-05-14 23:02    [W:0.135 / U:0.892 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site