lkml.org 
[lkml]   [2021]   [Apr]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v1 0/6] BHI/BHIe improvements for MHI power purposes
Date
This patch series improves the power up behavior by allowing MHI host driver to
set BHI and/or BHIe offsets early on in the preparation phase and fail pre-power
up if offsets are not found or not within a limited MMIO region. This also
allows MHI host to clean up the offsets in the unprepare after power down phase.

Going forward, controllers will be required to specify a reg_len field which
will be used to check whether the BHI/BHIe offsets are in range or not.

This series has been tested on X86_64 architecture with the PCI generic driver
as controller and an SDX55 device.

Bhaumik Bhatt (6):
bus: mhi: core: Set BHI/BHIe offsets on power up preparation
bus: mhi: core: Set BHI and BHIe pointers to NULL in clean-up
bus: mhi: Add MMIO region length to controller structure
ath11k: set register access length for MHI driver
bus: mhi: pci_generic: Set register access length for MHI driver
bus: mhi: core: Add range checks for BHI and BHIe

drivers/bus/mhi/core/init.c | 58 +++++++++++++++++++++++------------
drivers/bus/mhi/core/pm.c | 28 +++--------------
drivers/bus/mhi/pci_generic.c | 1 +
drivers/net/wireless/ath/ath11k/mhi.c | 1 +
include/linux/mhi.h | 2 ++
5 files changed, 47 insertions(+), 43 deletions(-)

--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project

\
 
 \ /
  Last update: 2021-04-16 20:48    [W:0.216 / U:0.192 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site