lkml.org 
[lkml]   [2021]   [Mar]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] leds: leds-dual-gpio: Add dual GPIO LEDs driver
Date
From: Hermes Zhang <chenhuiz@axis.com>

Introduce a new Dual GPIO LED driver. These two GPIOs LED will act as
one LED as normal GPIO LED but give the possibility to change the
intensity in four levels: OFF, LOW, MIDDLE and HIGH.
---
drivers/leds/Kconfig | 9 +++
drivers/leds/Makefile | 1 +
drivers/leds/leds-dual-gpio.c | 136 ++++++++++++++++++++++++++++++++++
3 files changed, 146 insertions(+)
create mode 100644 drivers/leds/leds-dual-gpio.c

diff --git a/drivers/leds/Kconfig b/drivers/leds/Kconfig
index b6742b4231bf..bc374d3b40ef 100644
--- a/drivers/leds/Kconfig
+++ b/drivers/leds/Kconfig
@@ -370,6 +370,15 @@ config LEDS_GPIO
defined as platform devices and/or OpenFirmware platform devices.
The code to use these bindings can be selected below.

+config LEDS_DUAL_GPIO
+ tristate "LED Support for Dual GPIO connected LEDs"
+ depends on LEDS_CLASS
+ depends on GPIOLIB || COMPILE_TEST
+ help
+ This option enables support for the two LEDs connected to GPIO
+ outputs. These two GPIO LEDs act as one LED in the sysfs and
+ perform different intensity by enable either one of them or both.
+
config LEDS_LP3944
tristate "LED Support for N.S. LP3944 (Fun Light) I2C chip"
depends on LEDS_CLASS
diff --git a/drivers/leds/Makefile b/drivers/leds/Makefile
index 2a698df9da57..10015cc81f79 100644
--- a/drivers/leds/Makefile
+++ b/drivers/leds/Makefile
@@ -30,6 +30,7 @@ obj-$(CONFIG_LEDS_DA903X) += leds-da903x.o
obj-$(CONFIG_LEDS_DA9052) += leds-da9052.o
obj-$(CONFIG_LEDS_FSG) += leds-fsg.o
obj-$(CONFIG_LEDS_GPIO) += leds-gpio.o
+obj-$(CONFIG_LEDS_DUAL_GPIO) += leds-dual-gpio.o
obj-$(CONFIG_LEDS_GPIO_REGISTER) += leds-gpio-register.o
obj-$(CONFIG_LEDS_HP6XX) += leds-hp6xx.o
obj-$(CONFIG_LEDS_INTEL_SS4200) += leds-ss4200.o
diff --git a/drivers/leds/leds-dual-gpio.c b/drivers/leds/leds-dual-gpio.c
new file mode 100644
index 000000000000..5d3b9be46f4b
--- /dev/null
+++ b/drivers/leds/leds-dual-gpio.c
@@ -0,0 +1,136 @@
+// SPDX-License-Identifier: GPL-2.0-only
+/*
+ * LEDs driver for GPIOs
+ *
+ * Copyright (C) 2021 Axis Communications AB
+ * Hermes Zhang <chenhui.zhang@axis.com>
+ */
+
+#include <linux/err.h>
+#include <linux/gpio.h>
+#include <linux/gpio/consumer.h>
+#include <linux/kernel.h>
+#include <linux/leds.h>
+#include <linux/module.h>
+#include <linux/of.h>
+#include <linux/platform_device.h>
+#include <linux/property.h>
+#include <linux/slab.h>
+
+#define GPIO_LOGICAL_ON 1
+#define GPIO_LOGICAL_OFF 0
+
+struct gpio_dual_leds_priv {
+ struct gpio_desc *low_gpio;
+ struct gpio_desc *high_gpio;
+ struct led_classdev cdev;
+};
+
+
+static void gpio_dual_led_set(struct led_classdev *led_cdev,
+ enum led_brightness value)
+{
+ struct gpio_dual_leds_priv *priv;
+
+ priv = container_of(led_cdev, struct gpio_dual_leds_priv, cdev);
+
+ if (value == LED_FULL) {
+ gpiod_set_value(priv->low_gpio, GPIO_LOGICAL_ON);
+ gpiod_set_value(priv->high_gpio, GPIO_LOGICAL_ON);
+ } else if (value < LED_FULL && value > LED_HALF) {
+ /* Enable high only */
+ gpiod_set_value(priv->low_gpio, GPIO_LOGICAL_OFF);
+ gpiod_set_value(priv->high_gpio, GPIO_LOGICAL_ON);
+ } else if (value <= LED_HALF && value > LED_OFF) {
+ /* Enable low only */
+ gpiod_set_value(priv->low_gpio, GPIO_LOGICAL_ON);
+ gpiod_set_value(priv->high_gpio, GPIO_LOGICAL_OFF);
+ } else {
+ gpiod_set_value(priv->low_gpio, GPIO_LOGICAL_OFF);
+ gpiod_set_value(priv->high_gpio, GPIO_LOGICAL_OFF);
+ }
+}
+
+static int gpio_dual_led_probe(struct platform_device *pdev)
+{
+ struct device *dev = &pdev->dev;
+ struct device_node *node = dev->of_node;
+ struct gpio_dual_leds_priv *priv = NULL;
+ int ret;
+ const char *state;
+
+ priv = devm_kzalloc(dev, sizeof(struct gpio_dual_leds_priv), GFP_KERNEL);
+ if (!priv)
+ return -ENOMEM;
+
+ priv->low_gpio = devm_gpiod_get(dev, "low", GPIOD_OUT_LOW);
+ ret = PTR_ERR_OR_ZERO(priv->low_gpio);
+ if (ret) {
+ dev_err(dev, "cannot get low-gpios %d\n", ret);
+ return ret;
+ }
+
+ priv->high_gpio = devm_gpiod_get(dev, "high", GPIOD_OUT_LOW);
+ ret = PTR_ERR_OR_ZERO(priv->high_gpio);
+ if (ret) {
+ dev_err(dev, "cannot get high-gpios %d\n", ret);
+ return ret;
+ }
+
+ priv->cdev.name = of_get_property(node, "label", NULL);
+ priv->cdev.max_brightness = LED_FULL;
+ priv->cdev.default_trigger =
+ of_get_property(node, "linux,default-trigger", NULL);
+ priv->cdev.brightness_set = gpio_dual_led_set;
+
+ ret = devm_led_classdev_register(dev, &priv->cdev);
+ if (ret < 0)
+ return ret;
+
+ if (!of_property_read_string(node, "default-state", &state)
+ && !strcmp(state, "on"))
+ gpio_dual_led_set(&priv->cdev, LED_FULL);
+ else
+ gpio_dual_led_set(&priv->cdev, LED_OFF);
+
+ platform_set_drvdata(pdev, priv);
+
+ return 0;
+}
+
+static void gpio_dual_led_shutdown(struct platform_device *pdev)
+{
+ struct gpio_dual_leds_priv *priv = platform_get_drvdata(pdev);
+
+ gpio_dual_led_set(&priv->cdev, LED_OFF);
+}
+
+static int gpio_dual_led_remove(struct platform_device *pdev)
+{
+ gpio_dual_led_shutdown(pdev);
+
+ return 0;
+}
+
+static const struct of_device_id of_gpio_dual_leds_match[] = {
+ { .compatible = "gpio-dual-leds", },
+ {},
+};
+
+MODULE_DEVICE_TABLE(of, of_gpio_dual_leds_match);
+
+static struct platform_driver gpio_dual_led_driver = {
+ .probe = gpio_dual_led_probe,
+ .remove = gpio_dual_led_remove,
+ .shutdown = gpio_dual_led_shutdown,
+ .driver = {
+ .name = "leds-dual-gpio",
+ .of_match_table = of_gpio_dual_leds_match,
+ },
+};
+
+module_platform_driver(gpio_dual_led_driver);
+
+MODULE_DESCRIPTION("Dual GPIO LED driver");
+MODULE_LICENSE("GPL v2");
+MODULE_ALIAS("platform:leds-dual-gpio");
--
2.20.1
\
 
 \ /
  Last update: 2021-03-11 14:14    [W:0.076 / U:0.300 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site