lkml.org 
[lkml]   [2021]   [Dec]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC 0/6] Sparse HART id support
On Fri, Dec 03, 2021 at 04:20:32PM -0800, Atish Patra wrote:
> Currently, sparse hartid is not supported for Linux RISC-V for the following
> reasons.
> 1. Both spinwait and ordered booting method uses __cpu_up_stack/task_pointer
> which is an array size of NR_CPUs.
> 2. During early booting, any hartid greater than NR_CPUs are not booted at all.
> 3. riscv_cpuid_to_hartid_mask uses struct cpumask for generating hartid bitmap.
> 4. SBI v0.2 implementation uses NR_CPUs as the maximum hartid number while
> generating hartmask.
>
> In order to support sparse hartid, the hartid & NR_CPUS needs to be disassociated
> which was logically incorrect anyways. NR_CPUs represent the maximum logical|
> CPU id configured in the kernel while the hartid represent the physical hartid
> stored in mhartid CSR defined by the privilege specification. Thus, hartid
> can have much greater value than logical cpuid.

We already have a couple of architectures with logical to physical CPU
id maps. See cpu_logical_map. Can we make that common and use it here?
That would also possibly allow for common populating the map from DT.

Rob

\
 
 \ /
  Last update: 2021-12-06 17:10    [W:1.218 / U:0.104 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site