lkml.org 
[lkml]   [2021]   [Dec]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 1/2] dt-bindings: phy: ti,tcan104x-can: Document mux-states property
Date
On some boards, for routing CAN signals from controller to transceivers,
muxes might need to be set. This can be implemented using mux-states
property. Therefore, document the same in the respective bindings.

Signed-off-by: Aswath Govindraju <a-govindraju@ti.com>
---
.../devicetree/bindings/phy/ti,tcan104x-can.yaml | 10 ++++++++++
1 file changed, 10 insertions(+)

diff --git a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
index 6107880e5246..7b9216e43b58 100644
--- a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
+++ b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
@@ -37,6 +37,15 @@ properties:
max bit rate supported in bps
minimum: 1

+ mux-states:
+ description:
+ mux controller node to route the signals from controller to
+ transceiver. Two arguments can be present depending on the
+ mux chip. If one argument is used then it represents the state
+ to be set on the mux-chip. If there are two arguments then the
+ first argument is the control line and the second argument is
+ its corresponding state to be set, on the mux-chip.
+
required:
- compatible
- '#phy-cells'
@@ -53,4 +62,5 @@ examples:
max-bitrate = <5000000>;
standby-gpios = <&wakeup_gpio1 16 GPIO_ACTIVE_LOW>;
enable-gpios = <&main_gpio1 67 GPIO_ACTIVE_HIGH>;
+ mux-states = <&mux0 1>;
};
--
2.17.1
\
 
 \ /
  Last update: 2021-12-14 15:30    [W:0.077 / U:0.100 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site