lkml.org 
[lkml]   [2021]   [Dec]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 1/2] dt-bindings: phy: ti,tcan104x-can: Document mux-states property
From
Date
Hi Rob,

On 16/12/21 2:10 am, Rob Herring wrote:
> On Tue, Dec 14, 2021 at 07:59:07PM +0530, Aswath Govindraju wrote:
>> On some boards, for routing CAN signals from controller to transceivers,
>> muxes might need to be set. This can be implemented using mux-states
>> property. Therefore, document the same in the respective bindings.
>>
>> Signed-off-by: Aswath Govindraju <a-govindraju@ti.com>
>> ---
>> .../devicetree/bindings/phy/ti,tcan104x-can.yaml | 10 ++++++++++
>> 1 file changed, 10 insertions(+)
>>
>> diff --git a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
>> index 6107880e5246..7b9216e43b58 100644
>> --- a/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
>> +++ b/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml
>> @@ -37,6 +37,15 @@ properties:
>> max bit rate supported in bps
>> minimum: 1
>>
>> + mux-states:
>> + description:
>> + mux controller node to route the signals from controller to
>> + transceiver. Two arguments can be present depending on the
>> + mux chip. If one argument is used then it represents the state
>> + to be set on the mux-chip. If there are two arguments then the
>> + first argument is the control line and the second argument is
>> + its corresponding state to be set, on the mux-chip.
>> +
>
> You are still describing how the mux-states works. What the cells
> contain and how many are opaque to this binding. Here you need to
> describe how many muxes you have and what they are controlling as that
> is what is specific to this binding. If there is only one, this boils
> down to 'maxItems: 1'. It's just like reg, interrupts, clocks, etc.
>


Got it. Thank you for the clarification. Amending the description to the
following,

mux-states:
description:
mux controller node to route the signals from controller to
transceiver.
maxItems: 1

Thanks,
Aswath

>> required:
>> - compatible
>> - '#phy-cells'
>> @@ -53,4 +62,5 @@ examples:
>> max-bitrate = <5000000>;
>> standby-gpios = <&wakeup_gpio1 16 GPIO_ACTIVE_LOW>;
>> enable-gpios = <&main_gpio1 67 GPIO_ACTIVE_HIGH>;
>> + mux-states = <&mux0 1>;
>> };
>> --
>> 2.17.1
>>
>>

\
 
 \ /
  Last update: 2021-12-16 05:02    [W:0.045 / U:0.348 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site