lkml.org 
[lkml]   [2021]   [Dec]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH V3 net-next 0/3] add Vertexcom MSE102x support
Date
This patch series adds support for the Vertexcom MSE102x Homeplug GreenPHY
chips [1]. They can be connected either via RGMII, RMII or SPI to a host CPU.
These patches handles only the last one, with an Ethernet over SPI protocol
driver.

The code has been tested only on Raspberry Pi boards, but should work
on other platforms.

Changes in V3:
- drop IF_PORT_HOMEPLUG again, since it's actually not used

Changes in V2:
- improve lock handling for RX & TX path
- add new patch to introduce IF_PORT_HOMEPLUG as suggested by Andrew Lunn
- address all the comments by Jakub Kicinski, Andrew Lunn, Kernel test robot

[1] - http://www.vertexcom.com/p_homeplug_plc_en.html

Stefan Wahren (3):
dt-bindings: add vendor Vertexcom
dt-bindings: net: add Vertexcom MSE102x support
net: vertexcom: Add MSE102x SPI support

.../devicetree/bindings/net/vertexcom-mse102x.yaml | 71 ++
.../devicetree/bindings/vendor-prefixes.yaml | 2 +
drivers/net/ethernet/Kconfig | 1 +
drivers/net/ethernet/Makefile | 1 +
drivers/net/ethernet/vertexcom/Kconfig | 25 +
drivers/net/ethernet/vertexcom/Makefile | 6 +
drivers/net/ethernet/vertexcom/mse102x.c | 769 +++++++++++++++++++++
7 files changed, 875 insertions(+)
create mode 100644 Documentation/devicetree/bindings/net/vertexcom-mse102x.yaml
create mode 100644 drivers/net/ethernet/vertexcom/Kconfig
create mode 100644 drivers/net/ethernet/vertexcom/Makefile
create mode 100644 drivers/net/ethernet/vertexcom/mse102x.c

--
2.7.4

\
 
 \ /
  Last update: 2021-12-12 15:51    [W:0.045 / U:0.380 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site