lkml.org 
[lkml]   [2021]   [Oct]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3 11/25] PCI: aardvark: Remove redundant error fabrication when device read fails
On Thursday 21 October 2021 20:37:36 Naveen Naidu wrote:
> An MMIO read from a PCI device that doesn't exist or doesn't respond
> causes a PCI error. There's no real data to return to satisfy the
> CPU read, so most hardware fabricates ~0 data.
>
> The host controller drivers sets the error response values (~0) and
> returns an error when faulty hardware read occurs. But the error
> response value (~0) is already being set in PCI_OP_READ and
> PCI_USER_READ_CONFIG whenever a read by host controller driver fails.
>
> Thus, it's no longer necessary for the host controller drivers to
> fabricate any error response.
>
> This helps unify PCI error response checking and make error check
> consistent and easier to find.
>
> Signed-off-by: Naveen Naidu <naveennaidu479@gmail.com>

Reviewed-by: Pali Rohár <pali@kernel.org>

> ---
> drivers/pci/controller/pci-aardvark.c | 10 ++--------
> 1 file changed, 2 insertions(+), 8 deletions(-)
>
> diff --git a/drivers/pci/controller/pci-aardvark.c b/drivers/pci/controller/pci-aardvark.c
> index 596ebcfcc82d..1af772c76d06 100644
> --- a/drivers/pci/controller/pci-aardvark.c
> +++ b/drivers/pci/controller/pci-aardvark.c
> @@ -893,10 +893,8 @@ static int advk_pcie_rd_conf(struct pci_bus *bus, u32 devfn,
> u32 reg;
> int ret;
>
> - if (!advk_pcie_valid_device(pcie, bus, devfn)) {
> - *val = 0xffffffff;
> + if (!advk_pcie_valid_device(pcie, bus, devfn))
> return PCIBIOS_DEVICE_NOT_FOUND;
> - }
>
> if (pci_is_root_bus(bus))
> return pci_bridge_emul_conf_read(&pcie->bridge, where,
> @@ -920,7 +918,6 @@ static int advk_pcie_rd_conf(struct pci_bus *bus, u32 devfn,
> *val = CFG_RD_CRS_VAL;
> return PCIBIOS_SUCCESSFUL;
> }
> - *val = 0xffffffff;
> return PCIBIOS_SET_FAILED;
> }
>
> @@ -955,16 +952,13 @@ static int advk_pcie_rd_conf(struct pci_bus *bus, u32 devfn,
> *val = CFG_RD_CRS_VAL;
> return PCIBIOS_SUCCESSFUL;
> }
> - *val = 0xffffffff;
> return PCIBIOS_SET_FAILED;
> }
>
> /* Check PIO status and get the read result */
> ret = advk_pcie_check_pio_status(pcie, allow_crs, val);
> - if (ret < 0) {
> - *val = 0xffffffff;
> + if (ret < 0)
> return PCIBIOS_SET_FAILED;
> - }
>
> if (size == 1)
> *val = (*val >> (8 * (where & 3))) & 0xff;
> --
> 2.25.1
>

\
 
 \ /
  Last update: 2021-10-21 17:58    [W:0.201 / U:0.096 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site