lkml.org 
[lkml]   [2021]   [Oct]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 03/25] PCI: Use SET_PCI_ERROR_RESPONSE() when device not found
Date
An MMIO read from a PCI device that doesn't exist or doesn't respond
causes a PCI error. There's no real data to return to satisfy the
CPU read, so most hardware fabricates ~0 data.

Use SET_PCI_ERROR_RESPONSE() to set the error response, when a faulty
read occurs.

This helps unify PCI error response checking and make error check
consistent and easier to find.

Signed-off-by: Naveen Naidu <naveennaidu479@gmail.com>
---
drivers/pci/access.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/pci/access.c b/drivers/pci/access.c
index 0f732ba2f71a..a6bcbad04d89 100644
--- a/drivers/pci/access.c
+++ b/drivers/pci/access.c
@@ -529,7 +529,7 @@ EXPORT_SYMBOL(pcie_capability_clear_and_set_dword);
int pci_read_config_byte(const struct pci_dev *dev, int where, u8 *val)
{
if (pci_dev_is_disconnected(dev)) {
- *val = ~0;
+ SET_PCI_ERROR_RESPONSE(val);
return PCIBIOS_DEVICE_NOT_FOUND;
}
return pci_bus_read_config_byte(dev->bus, dev->devfn, where, val);
@@ -539,7 +539,7 @@ EXPORT_SYMBOL(pci_read_config_byte);
int pci_read_config_word(const struct pci_dev *dev, int where, u16 *val)
{
if (pci_dev_is_disconnected(dev)) {
- *val = ~0;
+ SET_PCI_ERROR_RESPONSE(val);
return PCIBIOS_DEVICE_NOT_FOUND;
}
return pci_bus_read_config_word(dev->bus, dev->devfn, where, val);
@@ -550,7 +550,7 @@ int pci_read_config_dword(const struct pci_dev *dev, int where,
u32 *val)
{
if (pci_dev_is_disconnected(dev)) {
- *val = ~0;
+ SET_PCI_ERROR_RESPONSE(val);
return PCIBIOS_DEVICE_NOT_FOUND;
}
return pci_bus_read_config_dword(dev->bus, dev->devfn, where, val);
--
2.25.1
\
 
 \ /
  Last update: 2021-10-21 17:11    [W:0.129 / U:1.920 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site