lkml.org 
[lkml]   [2021]   [Oct]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v13 00/10] Add support for Hikey 970 PCIe
Date
Hi Lorenzo,

That's basically the same patches sent on v12, with the acked-by from
the driver's maintainer (Xiaowei Song) properly added on each patch
of the series.

The pcie-kirin PCIe driver contains internally a PHY interface for
Kirin 960, but it misses support for Kirin 970.

Patch1 contains a PHY for Kirin 970 PCIe.

The remaining patches add support for Kirin 970 at the pcie-kirin driver, and
add the needed logic to compile it as module and to allow to dynamically
remove the driver in runtime.

Tested on HiKey970:

# lspci -D -PP
0000:00:00.0 PCI bridge: Huawei Technologies Co., Ltd. Device 3670 (rev 01)
0000:00:00.0/01:00.0 PCI bridge: PLX Technology, Inc. PEX 8606 6 Lane, 6 Port PCI Express Gen 2 (5.0 GT/s) Switch (rev ba)
0000:00:00.0/01:00.0/02:01.0 PCI bridge: PLX Technology, Inc. PEX 8606 6 Lane, 6 Port PCI Express Gen 2 (5.0 GT/s) Switch (rev ba)
0000:00:00.0/01:00.0/02:04.0 PCI bridge: PLX Technology, Inc. PEX 8606 6 Lane, 6 Port PCI Express Gen 2 (5.0 GT/s) Switch (rev ba)
0000:00:00.0/01:00.0/02:05.0 PCI bridge: PLX Technology, Inc. PEX 8606 6 Lane, 6 Port PCI Express Gen 2 (5.0 GT/s) Switch (rev ba)
0000:00:00.0/01:00.0/02:07.0 PCI bridge: PLX Technology, Inc. PEX 8606 6 Lane, 6 Port PCI Express Gen 2 (5.0 GT/s) Switch (rev ba)
0000:00:00.0/01:00.0/02:09.0 PCI bridge: PLX Technology, Inc. PEX 8606 6 Lane, 6 Port PCI Express Gen 2 (5.0 GT/s) Switch (rev ba)
0000:00:00.0/01:00.0/02:01.0/03:00.0 Non-Volatile memory controller: Samsung Electronics Co Ltd Device a809
0000:00:00.0/01:00.0/02:07.0/06:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 07)

Tested on HiKey960:

# lspci -D
0000:00:00.0 PCI bridge: Huawei Technologies Co., Ltd. Device 3660 (rev 01)

---

v13:
- Added Xiaowei's ack for the series.

v12:
- Change a comment at patch 1 to not use c99 style.

v11:
- patch 5 changed to use the right PCIe topology
- all other patches are identical to v10.

v10:
- patch 1: dropped magic numbers from PHY driver
- patch 5: allow pcie child nodes without reset-gpios
- all other patches are identical to v9.

v9:
- Did some cleanups at patches 1 and 5

Mauro Carvalho Chehab (10):
PCI: kirin: Reorganize the PHY logic inside the driver
PCI: kirin: Add support for a PHY layer
PCI: kirin: Use regmap for APB registers
PCI: kirin: Add support for bridge slot DT schema
PCI: kirin: Add Kirin 970 compatible
PCI: kirin: Add MODULE_* macros
PCI: kirin: Allow building it as a module
PCI: kirin: Add power_off support for Kirin 960 PHY
PCI: kirin: fix poweroff sequence
PCI: kirin: Allow removing the driver

drivers/pci/controller/dwc/Kconfig | 2 +-
drivers/pci/controller/dwc/pcie-kirin.c | 644 ++++++++++++++++++------
2 files changed, 498 insertions(+), 148 deletions(-)

--
2.31.1


\
 
 \ /
  Last update: 2021-10-18 09:08    [W:0.161 / U:0.160 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site