lkml.org 
[lkml]   [2021]   [Jan]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v4 0/3] J7200: Add support for GPIO and higher speed modes in MMCSD subsystems
Date
The following series of patches
- Add support for GPIO subsystem in main and wakeup domains.
- Add voltage regulator device tree nodes and their corresponding pinmux
to support power cycle and voltage switch required for UHS-I modes
- sets respective tags in sdhci0 node to support higher speeds
- remove no-1-8-v tag from sdhci1 node to support UHS-I modes

performance test logs using EXT4 filesystem
- For eMMC HS400 speed mode,
https://pastebin.ubuntu.com/p/gDxBCwtkt8/
- For SD SDR104 speed mode,
https://pastebin.ubuntu.com/p/tHYTn2wxwg/

Changes since v3:
- Removed patch (1 in v3).
- Rebased and included patches that add support for GPIO from series [1].
- Re-ran the performace tests for SD and eMMC.

Changes since v2:
- Added main_gpio0 DT node
- Added voltage regulator device tree nodes required to support UHS-I modes

Changes since v1:
- squashed the two patches into one
- added performance logs for the above mentioned speed modes

Aswath Govindraju (1):
arm64: dts: ti: k3-j7200: Add support for higher speed modes in MMCSD
subsystems

[1] - https://lkml.org/lkml/2020/11/17/1489

Faiz Abbas (2):
arm64: dts: ti: k3-j7200: Add gpio nodes
arm64: dts: ti: k3-j7200-common-proc-board: Disable unused gpio
modules

.../dts/ti/k3-j7200-common-proc-board.dts | 47 ++++++++++++
arch/arm64/boot/dts/ti/k3-j7200-main.dtsi | 75 ++++++++++++++++++-
.../boot/dts/ti/k3-j7200-mcu-wakeup.dtsi | 34 +++++++++
3 files changed, 155 insertions(+), 1 deletion(-)

--
2.17.1

\
 
 \ /
  Last update: 2021-01-28 16:31    [W:0.036 / U:0.200 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site