lkml.org 
[lkml]   [2021]   [Jan]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] docs: gpio: intro: Improve HTML formatting
Date
Currently the HTML output for Documentation/driver-api/gpio/intro.rst
doesn't look right. The lines that start with LOW or HIGH are formatted
in bold, while the next line after each is not bold.

With this patch, the HTML looks better.

Signed-off-by: Jonathan Neuschäfer <j.neuschaefer@gmx.net>
---
Documentation/driver-api/gpio/intro.rst | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/Documentation/driver-api/gpio/intro.rst b/Documentation/driver-api/gpio/intro.rst
index 74591489d0b55..94dd7185e76eb 100644
--- a/Documentation/driver-api/gpio/intro.rst
+++ b/Documentation/driver-api/gpio/intro.rst
@@ -106,11 +106,11 @@ don't. When you need open drain signaling but your hardware doesn't directly
support it, there's a common idiom you can use to emulate it with any GPIO pin
that can be used as either an input or an output:

- LOW: gpiod_direction_output(gpio, 0) ... this drives the signal and overrides
- the pullup.
+ **LOW**: ``gpiod_direction_output(gpio, 0)`` ... this drives the signal and
+ overrides the pullup.

- HIGH: gpiod_direction_input(gpio) ... this turns off the output, so the pullup
- (or some other device) controls the signal.
+ **HIGH**: ``gpiod_direction_input(gpio)`` ... this turns off the output, so
+ the pullup (or some other device) controls the signal.

The same logic can be applied to emulate open source signaling, by driving the
high signal and configuring the GPIO as input for low. This open drain/open
--
2.29.2
\
 
 \ /
  Last update: 2021-01-01 21:47    [W:2.373 / U:0.004 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site