Messages in this thread | | | From | Landen Chao <> | Subject | [PATCH net-next v3 0/6] net-next: dsa: mt7530: add support for MT7531 | Date | Fri, 4 Sep 2020 22:21:55 +0800 |
| |
This patch series adds support for MT7531.
MT7531 is the next generation of MT7530 which could be found on Mediatek router platforms such as MT7622 or MT7629.
It is also a 7-ports switch with 5 giga embedded phys, 2 cpu ports, and the same MAC logic of MT7530. Cpu port 6 only supports SGMII interface. Cpu port 5 supports either RGMII or SGMII in different HW SKU, but cannot be muxed to PHY of port 0/4 like mt7530. Due to support for SGMII interface, pll, and pad setting are different from MT7530.
MT7531 SGMII interface can be configured in following mode: - 'SGMII AN mode' with in-band negotiation capability which is compatible with PHY_INTERFACE_MODE_SGMII. - 'SGMII force mode' without in-band negotiation which is compatible with 10B/8B encoding of PHY_INTERFACE_MODE_1000BASEX with fixed full-duplex and fixed pause. - 2.5 times faster clocked 'SGMII force mode' without in-band negotiation which is compatible with 10B/8B encoding of PHY_INTERFACE_MODE_2500BASEX with fixed full-duplex and fixed pause.
v2 -> v3 - Keep the same setup logic of mt7530/mt7621 because these series of patches is for adding mt7531 hardware. - Do not adjust rgmii delay when vendor phy driver presents in order to prevent double adjustment by suggestion of Andrew Lunn. - Remove redundant 'Example 4' from dt-bindings by suggestion of Rob Herring. - Fix typo.
v1 -> v2 - change phylink_validate callback function to support full-duplex gigabit only to match hardware capability. - add description of SGMII interface. - configure mt7531 cpu port in fastest speed by default. - parse SGMII control word for in-band negotiation mode. - configure RGMII delay based on phy.rst. - Rename the definition in the header file to avoid potential conflicts. - Add wrapper function for mdio read/write to support both C22 and C45. - correct fixed-link speed of 2500base-x in dts. - add MT7531 port mirror setting.
Landen Chao (6): net: dsa: mt7530: Refine message in Kconfig net: dsa: mt7530: Extend device data ready for adding a new hardware dt-bindings: net: dsa: add new MT7531 binding to support MT7531 net: dsa: mt7530: Add the support of MT7531 switch arm64: dts: mt7622: add mt7531 dsa to mt7622-rfb1 board arm64: dts: mt7622: add mt7531 dsa to bananapi-bpi-r64 board
.../devicetree/bindings/net/dsa/mt7530.txt | 10 +- .../dts/mediatek/mt7622-bananapi-bpi-r64.dts | 44 + arch/arm64/boot/dts/mediatek/mt7622-rfb1.dts | 57 +- drivers/net/dsa/Kconfig | 6 +- drivers/net/dsa/mt7530.c | 1194 +++++++++++++++-- drivers/net/dsa/mt7530.h | 259 +++- 6 files changed, 1463 insertions(+), 107 deletions(-)
-- 2.17.1
| |