lkml.org 
[lkml]   [2020]   [Sep]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3 05/15] phy: tegra: xusb: Rearrange UPHY init on Tegra210
On Wed, Sep 09, 2020 at 04:10:31PM +0800, JC Kuo wrote:
> This commit is a preparation for enabling XUSB SC7 support.
> It rearranges Tegra210 XUSB PADCTL UPHY initialization sequence,
> for the following reasons:
>
> 1. PLLE hardware power sequencer has to be enabled only after both
> PEX UPHY PLL and SATA UPHY PLL are initialized.
> tegra210_uphy_init() -> tegra210_pex_uphy_enable()
> -> tegra210_sata_uphy_enable()
> -> tegra210_plle_hw_sequence_start()
> -> tegra210_aux_mux_lp0_clamp_disable()
>
> 2. At cold boot and SC7 exit, the following bits must be cleared after
> PEX/SATA lanes are out of IDDQ (IDDQ_DISABLE=1).
> a. XUSB_PADCTL_ELPG_PROGRAM1_AUX_MUX_LP0_CLAMP_EN,
> b. XUSB_PADCTL_ELPG_PROGRAM1_AUX_MUX_LP0_CLAMP_EN_EARLY
> c. XUSB_PADCTL_ELPG_PROGRAM1_AUX_MUX_LP0_VCORE_DOWN
>
> tegra210_pex_uphy_enable() and tegra210_sata_uphy_enable() are in
> charge of bringing lanes out of IDDQ, and then AUX_MUX_LP0_* bits
> will be cleared by tegra210_aux_mux_lp0_clamp_disable().
>
> Signed-off-by: JC Kuo <jckuo@nvidia.com>
> ---
> v3:
> make separate changes
> use "unsigned int" instead "int" type for PHY index
> add blank line for better readability
>
> drivers/phy/tegra/xusb-tegra210.c | 203 +++++++++++++++---------------
> drivers/phy/tegra/xusb.h | 4 +-
> 2 files changed, 102 insertions(+), 105 deletions(-)

Acked-by: Thierry Reding <treding@nvidia.com>
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2020-09-28 15:09    [W:0.157 / U:0.092 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site