Messages in this thread | | | Subject | Re: [PATCH v6 1/6] tty: serial: qcom_geni_serial: Use OPP API to set clk/perf state | From | Rajendra Nayak <> | Date | Tue, 30 Jun 2020 17:46:52 +0530 |
| |
On 6/25/2020 10:38 AM, Bjorn Andersson wrote: > On Mon 15 Jun 05:02 PDT 2020, Rajendra Nayak wrote: > >> geni serial needs to express a perforamnce state requirement on CX >> powerdomain depending on the frequency of the clock rates. >> Use OPP table from DT to register with OPP framework and use >> dev_pm_opp_set_rate() to set the clk/perf state. >> >> Signed-off-by: Rajendra Nayak <rnayak@codeaurora.org> >> Reviewed-by: Matthias Kaehlcke <mka@chromium.org> >> Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org> >> Cc: Akash Asthana <akashast@codeaurora.org> >> Cc: linux-serial@vger.kernel.org > > Picked up patch 1 and 2 through the qcom tree.
thanks Bjorn
> As Mark requested, please don't lump together patches that doesn't > actually depend on each other in the same series - it's quite confusing > to know what to pick and not.
Sorry for the confusion, I will try and split them into driver specific patches henceforth. For this series though, I see that you have merged the entire ICC series for QUP and QSPI into for-next of the qcom tree. In which case it perhaps makes sense for you to pull in the QSPI change from this series as well? i.e PATCH 6/6. If so, I will rebase the patch on your for-next and resend (Its already Ack'ed by Mark)
thanks, Rajendra
-- QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, hosted by The Linux Foundation
| |