lkml.org 
[lkml]   [2020]   [Feb]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[v1] drm/msm/dsi/pll: call vco set rate explicitly
Date
For a given byte clock, if VCO recalc value is exactly same as
vco set rate value, vco_set_rate does not get called assuming
VCO is already set to required value. But Due to GDSC toggle,
VCO values are erased in the HW. To make sure VCO is programmed
correctly, we forcefully call set_rate from vco_prepare.

Signed-off-by: Harigovindan P <harigovi@codeaurora.org>
---

Changes in v1:
- Calling set rate from vco_prepare

drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c | 6 ++++++
1 file changed, 6 insertions(+)

diff --git a/drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c b/drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c
index 1c89454..6ac04fc 100644
--- a/drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c
+++ b/drivers/gpu/drm/msm/dsi/pll/dsi_pll_10nm.c
@@ -411,6 +411,12 @@ static int dsi_pll_10nm_vco_prepare(struct clk_hw *hw)
if (pll_10nm->slave)
dsi_pll_enable_pll_bias(pll_10nm->slave);

+ rc = dsi_pll_10nm_vco_set_rate(hw,pll_10nm->vco_current_rate, 0);
+ if (rc) {
+ pr_err("vco_set_rate failed, rc=%d\n", rc);
+ return rc;
+ }
+
/* Start PLL */
pll_write(pll_10nm->phy_cmn_mmio + REG_DSI_10nm_PHY_CMN_PLL_CNTRL,
0x01);
--
2.7.4
\
 
 \ /
  Last update: 2020-02-06 10:12    [W:0.043 / U:0.792 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site