lkml.org 
[lkml]   [2020]   [Dec]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] regmap: irq: do not allow setting irq bits during ack
Date
Some interrupt controllers may not de-assert their interrupt if
bits are set when acknowledging the bits that caused the interrupt.

Take care to not apply the mask to the status until we are done
acknowledging the interrupt and take care to mask the bits according
for the ack_invert state.

This is needed to avoid a stuck interrupt case for the Gateworks
System Controller which uses ack_invert. If the status has the mask
applied before clearing the bits it will end up setting bits that
are enabled but were not the cause the interrupt which will keep
the GSC from ever de-asserting its interrupt.

Cc: Tony Lindgren <tony@atomide.com>
Cc: Laxminath Kasam <lkasam@codeaurora.org>
Cc: Robert Jones <rjones@gateworks.com>
Signed-off-by: Tim Harvey <tharvey@gateworks.com>
---
drivers/base/regmap/regmap-irq.c | 14 +++++++-------
1 file changed, 7 insertions(+), 7 deletions(-)

diff --git a/drivers/base/regmap/regmap-irq.c b/drivers/base/regmap/regmap-irq.c
index ad5c2de..560c641 100644
--- a/drivers/base/regmap/regmap-irq.c
+++ b/drivers/base/regmap/regmap-irq.c
@@ -496,29 +496,29 @@ static irqreturn_t regmap_irq_thread(int irq, void *d)
* doing a write per register.
*/
for (i = 0; i < data->chip->num_regs; i++) {
- data->status_buf[i] &= ~data->mask_buf[i];
-
- if (data->status_buf[i] && (chip->ack_base || chip->use_ack)) {
+ if ((data->status_buf[i] && ~data->mask_buf[i]) &&
+ (chip->ack_base || chip->use_ack)) {
reg = chip->ack_base +
(i * map->reg_stride * data->irq_reg_stride);
if (chip->ack_invert)
ret = regmap_write(map, reg,
- ~data->status_buf[i]);
+ ~data->status_buf[i] & data->mask_buf[i]);
else
ret = regmap_write(map, reg,
- data->status_buf[i]);
+ data->status_buf[i] & ~data->mask_buf[i]);
if (chip->clear_ack) {
if (chip->ack_invert && !ret)
ret = regmap_write(map, reg,
- data->status_buf[i]);
+ data->status_buf[i] & ~data->mask_buf[i]);
else if (!ret)
ret = regmap_write(map, reg,
- ~data->status_buf[i]);
+ ~data->status_buf[i] & data->mask_buf[i]);
}
if (ret != 0)
dev_err(map->dev, "Failed to ack 0x%x: %d\n",
reg, ret);
}
+ data->status_buf[i] &= ~data->mask_buf[i];
}

for (i = 0; i < chip->num_irqs; i++) {
--
2.7.4
\
 
 \ /
  Last update: 2020-12-29 00:03    [W:0.041 / U:0.300 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site