Messages in this thread | | | From | Kevin Hilman <> | Subject | Re: [PATCH v2 0/5] usb: dwc-meson-g12a: Add support for USB on S400 board | Date | Fri, 02 Oct 2020 11:23:46 -0700 |
| |
Neil Armstrong <narmstrong@baylibre.com> writes:
> Hi Kevin, > > On 17/09/2020 08:59, Neil Armstrong wrote: >> The Amlogic AXG is close to the GXL Glue but with a single OTG PHY. >> >> It needs the same init sequence as GXL & GXM, but it seems it doesn't need >> the host disconnect bit. >> >> The Glue driver reuses the already implemented GXL & GXM work. >> >> The USB2 PHY driver needs a slight tweak to keep the OTG detection working. >> >> Changes since v1 at [1]: >> - s/close from/close to/g >> - collected review tags >> - added small comment about phy management in patch 3 >> - removed status = "okay" in patch 4 >> - removed invalid phy-supply of phy1 in patch 5 >> >> [1] http://lore.kernel.org/r/20200909160409.8678-1-narmstrong@baylibre.com >> >> Neil Armstrong (5): >> phy: amlogic: phy-meson-gxl-usb2: keep ID pull-up even in Host mode >> dt-bindings: usb: amlogic,meson-g12a-usb-ctrl: add the Amlogic AXG >> Families USB Glue Bindings >> usb: dwc-meson-g12a: Add support for USB on AXG SoCs >> arm64: dts: meson-axg: add USB nodes >> arm64: dts: meson-axg-s400: enable USB OTG > > Can you pick the DT patches ?
Yes, queued up.
Since we're already at -rc7, this may not make it until v5.11.
Kevin
| |