lkml.org 
[lkml]   [2020]   [Jan]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3 3/6] dt-bindings: mfd: da9062: add regulator voltage selection documentation
On Tue, Jan 07, 2020 at 09:36:54AM +0100, Marco Felsch wrote:
> On 19-12-17 12:58, Mark Brown wrote:

> > This doesn't say anything about how the GPIO input is expected to be
> > controlled, for voltage setting any runtime control would need to be
> > done by the driver and it sounds like that's all that can be controlled.
> > The way this reads I'd expect one use of this to be for fast voltage
> > setting for example (you could even combine that with suspend sequencing
> > using the internal sequencer if you mux back to the sequencer during
> > suspend).

> The input signal is routed trough the da9062 gpio block to the
> regualtors. You can't set any voltage value using a gpio instead you
> decide which voltage setting is applied. The voltage values for
> runtime/suspend comes from the dt-data. No it's not just a fast
> switching option imagine the system suspend case where the cpu and soc
> voltage can be reduced to a very low value. Older soc's like the imx6
> signaling this state by a hard wired gpio line because the soc and
> cpu cores don't work properly on such low voltage values. This is
> my use case and I can't use the sequencer.

My point is that I can't tell any of this from the description.
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2020-01-07 14:10    [W:0.052 / U:0.508 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site