lkml.org 
[lkml]   [2020]   [Jan]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3 3/6] dt-bindings: mfd: da9062: add regulator voltage selection documentation
Hi Mark,

On 19-12-17 12:58, Mark Brown wrote:
> On Tue, Dec 17, 2019 at 08:35:33AM +0100, Marco Felsch wrote:
> > On 19-12-16 11:44, Mark Brown wrote:
>
> > > What I'm saying is that I think the binding needs to explicitly talk
> > > about that since at the minute it's really confusing reading it as it
> > > is, it sounds very much like it's trying to override that in a chip
> > > specific fashion as using gpiolib and the GPIO bindings for pinmuxing is
> > > really quite unusual.
>
> > Hm.. I still think that we don't mux the pin to some special function.
> > It is still a gpio input pin and if we don't request the pin we could
> > read the input from user-space too and get a 'valid' value. Muxing would
> > happen if we change the pad to so called _alternate_ function. Anyway,
> > lets find a binding description:
>
> I don't think any of this makes much difference from a user point of
> view.
>
> > IMHO this is very descriptive and needs no update.
>
> > description:
> > - A GPIO reference to a local general purpose input, [1] calls it GPI.
> > The DA9062 regulators can select between voltage-a/-b settings.
> > Each regulator has a VBUCK*_GPI or VLDO*_GPI input to determine the
> > active setting. In front of the VBUCK*_GPI/VLDO*_GPI input is a mux
> > to select between different signal sources, valid sources are: the
> > internal sequencer, GPI1, GPI2 and GPI3. See [1] table 63 for more
> > information. Most the time the internal sequencer is fine but
> > sometimes it is necessary to use the signal from the DA9062 GPI
> > pads. This binding covers the second use case.
> > Attention: Sharing the same GPI for other purposes or across multiple
> > regulators is possible but the polarity setting must equal.
>
> This doesn't say anything about how the GPIO input is expected to be
> controlled, for voltage setting any runtime control would need to be
> done by the driver and it sounds like that's all that can be controlled.
> The way this reads I'd expect one use of this to be for fast voltage
> setting for example (you could even combine that with suspend sequencing
> using the internal sequencer if you mux back to the sequencer during
> suspend).

The input signal is routed trough the da9062 gpio block to the
regualtors. You can't set any voltage value using a gpio instead you
decide which voltage setting is applied. The voltage values for
runtime/suspend comes from the dt-data. No it's not just a fast
switching option imagine the system suspend case where the cpu and soc
voltage can be reduced to a very low value. Older soc's like the imx6
signaling this state by a hard wired gpio line because the soc and
cpu cores don't work properly on such low voltage values. This is
my use case and I can't use the sequencer.

Regards,
Marco

\
 
 \ /
  Last update: 2020-01-07 09:37    [W:0.064 / U:0.220 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site