lkml.org 
[lkml]   [2020]   [Jan]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 00/14] media: sun4i-csi: A10/A20 CSI1 and R40 CSI0 support
Hi Sakari,


On Mon, Dec 16, 2019 at 12:59 AM Chen-Yu Tsai <wens@kernel.org> wrote:
>
> From: Chen-Yu Tsai <wens@csie.org>
>
> Hi everyone,
>
> This series adds basic support for CSI1 on Allwinner A10/A20 and CSI0 on
> Allwinner R40. The CSI1 block has the same structure and layout as the
> CSI0 block. Differences include:
>
> - Only one channel in BT.656 instead of four in CSI0
> - 10-bit raw data input vs 8-bit in CSI0
> - 24-bit RGB888/YUV444 input vs 16-bit RGB565/YUV422 in CSI0
> - No ISP hardware (CSI SCLK not needed)
>
> The CSI0 block in the Allwinner R40 SoC looks to be the same as the one
> in the A20. The register maps line up, and they support the same
> features. The R40 appears to support BT.1120 based on the feature
> overview, but it is not mentioned anywhere else. Also like the A20, the
> ISP is not mentioned, but the CSI special clock needs to be enabled for
> the hardware to function. The manual does state that the CSI special
> clock is the TOP clock for all CSI hardware, but currently no hardware
> exists for us to test if CSI1 also depends on it or not.
>
> Included are a couple of fixes for signal polarity and DRAM offset
> handling.
>
> Patches 1 and 2 add compatible strings for the newly supported hardware.
>
> Patches 3 and 4 fix the polarity setting of [HV]sync and data sampling.
> Allwinner hardware uses [HV]ref semantics instead of [HV]sync.
>
> Patch 5 deals with the DRAM offset when the CSI hardware does DMA. The
> hardware does DMA directly to the memory bus, thus requiring the address
> to not be offset like when DMA is done over the system bus.
>
> Patch 6 add support for the CSI1 hardware block. For now this simply
> means not requiring the ISP clock.
>
> Patches 7 and 8 add CSI1 to A10 (sun4i) and A20 (sun7i) dtsi files.
>
> Patch 9 adds I2C pixmuxing options for the R40. Used in the last example
> patch.
>
> Patch 10 adds a compatible string for the R40's MBUS (memory bus).
>
> Patch 11 adds CSI0 to the R40 dtsi file
>
> Patches 12 through 14 are examples of cameras hooked up to boards.
>
> Please have a look. The MBUS compatible patch is likely to conflict
> with a DT binding conversion patch Maxime sent out.
>
> Also, I sent out an email asking about the polarity settings for
> [HV]sync, how to signal the use of [HV]ref instead, and how to pass
> timings from the camera to the capture interface. So far I haven't
> heard back. In particular I think the OV7670 driver has inverted
> polarity settings for HSYNC. Not sure about VSYNC.
>
>
> Regards
> ChenYu
>
>
> Chen-Yu Tsai (14):
> dt-bindings: media: sun4i-csi: Add compatible for CSI1 on A10/A20
> dt-bindings: media: sun4i-csi: Add compatible for CSI0 on R40
> media: sun4i-csi: Fix data sampling polarity handling
> media: sun4i-csi: Fix [HV]sync polarity handling
> media: sun4i-csi: Deal with DRAM offset
> media: sun4i-csi: Add support for A10 CSI1 camera sensor interface

Any news on these 6 patches? I believe they have the required acks.

We (sunxi maintainers) will take the remain patches once these are in.

ChenYu

> ARM: dts: sun4i: Add CSI1 controller and pinmux options
> ARM: dts: sun7i: Add CSI1 controller and pinmux options
> ARM: dts: sun8i: r40: Add I2C pinmux options
> dt-bindings: bus: sunxi: Add R40 MBUS compatible
> ARM: dts: sun8i: r40: Add device node for CSI0
> [DO NOT MERGE] ARM: dts: sun4i: cubieboard: Enable OV7670 camera on
> CSI1
> [DO NOT MERGE] ARM: dts: sun7i: cubieboard2: Enable OV7670 camera on
> CSI1
> [DO NOT MERGE] ARM: dts: sun8i-r40: bananapi-m2-ultra: Enable OV5640
> camera
>
> .../bindings/arm/sunxi/sunxi-mbus.txt | 1 +
> .../media/allwinner,sun4i-a10-csi.yaml | 14 +++-
> arch/arm/boot/dts/sun4i-a10-cubieboard.dts | 42 ++++++++++++
> arch/arm/boot/dts/sun4i-a10.dtsi | 35 ++++++++++
> arch/arm/boot/dts/sun7i-a20-cubieboard2.dts | 42 ++++++++++++
> arch/arm/boot/dts/sun7i-a20.dtsi | 36 ++++++++++
> .../boot/dts/sun8i-r40-bananapi-m2-ultra.dts | 67 +++++++++++++++++++
> arch/arm/boot/dts/sun8i-r40.dtsi | 64 ++++++++++++++++++
> .../platform/sunxi/sun4i-csi/sun4i_csi.c | 57 ++++++++++++++--
> .../platform/sunxi/sun4i-csi/sun4i_csi.h | 6 +-
> .../platform/sunxi/sun4i-csi/sun4i_dma.c | 20 ++++--
> 11 files changed, 370 insertions(+), 14 deletions(-)
>
> --
> 2.24.0
>

\
 
 \ /
  Last update: 2020-01-01 11:21    [W:0.157 / U:0.484 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site