lkml.org 
[lkml]   [2019]   [May]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v10 2/2] phy: Add driver for mixel mipi dphy found on NXP's i.MX8 SoCs
Hi,
On Tue, May 07, 2019 at 08:12:23PM +0200, Sam Ravnborg wrote:
> Hi Guido.
>
> Looks good now, stumbled upon a few details I missed in last round.
> With these considered / fixed you can add my
> Reviewed-by: Sam Ravnborg <sam@ravnborg.org>
>
> Sam
>
> > +#define CM(x) ( \
> > + ((x) < 32)?0xe0|((x)-16) : \
> > + ((x) < 64)?0xc0|((x)-32) : \
> > + ((x) < 128)?0x80|((x)-64) : \
> > + ((x) - 128))
> > +#define CN(x) (((x) == 1)?0x1f : (((CN_BUF)>>((x)-1))&0x1f))
> > +#define CO(x) ((CO_BUF)>>(8-(x))&0x3)
>
> A few spaces around the operators may help readability a little.
>
> > +static int phy_write(struct phy *phy, u32 value, unsigned int reg)
> > +{
> > + struct mixel_dphy_priv *priv = phy_get_drvdata(phy);
> > + int ret;
> > +
> > + ret = regmap_write(priv->regmap, reg, value);
> > + if (ret < 0)
> > + dev_err(&phy->dev, "Failed to write DPHY reg %d: %d", reg, ret);
>
> I have recently learned that one has to remember trailign "\n"- please
> add.
> Check all other dev_xxx as I noticed the newline is missing in a few
> more places.

Argh...I thought I've fixed these up already but that was in the
corresponding NWL driver only. Fixed now, thanks.

>
> > +
> > + dev_dbg(&phy->dev, "hs_clk/ref_clk=%ld/%ld ⩰ %d/%d\n",
> ^
>
> There was another of the symbols my terminal cannot show.
>

Thanks! I've incorporated your suggestions and will send out a v11 by
the end of the week in case there's more comments coming in.
Cheers,
-- Guido

\
 
 \ /
  Last update: 2019-05-08 10:37    [W:0.039 / U:4.768 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site