lkml.org 
[lkml]   [2019]   [Mar]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: rpi-b-rev2 can't detect hdmi display due to wrong hpd gpio pull in dts
Date
Helen Koike <helen.koike@collabora.com> writes:

> Hello,
>
> I have a rpi-b-rev2 (two holes, 512M) and when I was trying to test vc4
> driver, the HDMI wans't being detected.
>
> So I changed the hpd-gpios from ACTIVE_LOW to ACTIVE_HIGH and now it
> works correctly. I can see that modeprint from libdrm detects correctly
> when the display is plugged and when it is unpluggled.
>
> So I was wondering if this is just in my board or if there is an error
> in the dts (which I think it's unlikely).
>
> In any case I am dropping this email here in case anyone else see this
> problem, if you do, try appliying the patch below.

We even have the GPIO labeled as "HDMI_HPD_P" above, and dt-blob.dts
agrees.

Reviewed-by: Eric Anholt <eric@anholt.net>

Thanks! If Stefan doesn't pick this up shortly, I can.
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2019-03-04 21:27    [W:0.068 / U:0.520 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site