Messages in this thread | | | Subject | Re: rpi-b-rev2 can't detect hdmi display due to wrong hpd gpio pull in dts | From | Helen Koike <> | Date | Mon, 4 Mar 2019 18:54:00 -0300 |
| |
On 3/4/19 5:27 PM, Eric Anholt wrote: > Helen Koike <helen.koike@collabora.com> writes: > >> Hello, >> >> I have a rpi-b-rev2 (two holes, 512M) and when I was trying to test vc4 >> driver, the HDMI wans't being detected. >> >> So I changed the hpd-gpios from ACTIVE_LOW to ACTIVE_HIGH and now it >> works correctly. I can see that modeprint from libdrm detects correctly >> when the display is plugged and when it is unpluggled. >> >> So I was wondering if this is just in my board or if there is an error >> in the dts (which I think it's unlikely). >> >> In any case I am dropping this email here in case anyone else see this >> problem, if you do, try appliying the patch below. > > We even have the GPIO labeled as "HDMI_HPD_P" above, and dt-blob.dts > agrees.
You are right, I didn't notice it.
> > Reviewed-by: Eric Anholt <eric@anholt.net> > Thanks! If Stefan doesn't pick this up shortly, I can. >
Thanks for reviewing!
Helen
| |