lkml.org 
[lkml]   [2019]   [Mar]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
Subjectmegasas: Unexpected response from lun 1 while scanning, scan aborted
I am reporting an error that the scsi lun cannot initialize successfully when I
am emulating megasas scsi controller with qemu.

I am not sure if this is issue in qemu or linux kernel.

When 'lun=1' is specified, there is "Unexpected response from lun 1 while
scanning, scan aborted".

Everything works well if 'lun=0' is specified.


Below is the qemu cmdline involved:

-device megasas,id=scsi0 \
-device scsi-hd,drive=drive0,bus=scsi0.0,lun=1 \
-drive file=/home/zhang/img/test.img,if=none,id=drive0,format=raw


Below is the syslog related to 'scsi|SCSI'

# dmesg | grep SCSI
[ 0.392494] SCSI subsystem initialized
[ 0.460666] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 251)
[ 0.706788] sd 1:0:0:0: [sda] Attached SCSI disk
# dmesg | grep scsi
[ 0.511643] scsi host0: Avago SAS based MegaRAID driver
[ 0.523302] scsi 0:2:0:0: Unexpected response from lun 1 while scanning, scan aborted
[ 0.540364] scsi host1: ata_piix
[ 0.540780] scsi host2: ata_piix
[ 0.702396] scsi 1:0:0:0: Direct-Access ATA QEMU HARDDISK 2.5+ PQ: 0 ANSI: 5

When 'lun=1' is changed to 'lun=0', there is no issue.

Thank you very much!

Dongli Zhang

\
 
 \ /
  Last update: 2019-03-26 17:49    [W:0.071 / U:0.740 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site