lkml.org 
[lkml]   [2019]   [Dec]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] watchdog: qcom: Use platform_get_irq_optional() for bark irq
Date
platform_get_irq() prints an error message when the interrupt
is not available. So on platforms where bark interrupt is
not specified, following error message is observed on SDM845.

[ 2.975888] qcom_wdt 17980000.watchdog: IRQ index 0 not found

This is also seen on SC7180, SM8150 SoCs as well.
Fix this by using platform_get_irq_optional() instead.

Fixes: 36375491a4395654 ("watchdog: qcom: support pre-timeout when the bark irq is available")
Signed-off-by: Sai Prakash Ranjan <saiprakash.ranjan@codeaurora.org>
---
drivers/watchdog/qcom-wdt.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/watchdog/qcom-wdt.c b/drivers/watchdog/qcom-wdt.c
index a494543d3ae1..eb47fe5ed280 100644
--- a/drivers/watchdog/qcom-wdt.c
+++ b/drivers/watchdog/qcom-wdt.c
@@ -246,7 +246,7 @@ static int qcom_wdt_probe(struct platform_device *pdev)
}

/* check if there is pretimeout support */
- irq = platform_get_irq(pdev, 0);
+ irq = platform_get_irq_optional(pdev, 0);
if (irq > 0) {
ret = devm_request_irq(dev, irq, qcom_wdt_isr,
IRQF_TRIGGER_RISING,
--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation
\
 
 \ /
  Last update: 2019-12-13 07:50    [W:0.077 / U:0.376 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site