lkml.org 
[lkml]   [2019]   [Dec]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH 1/2] crypto: caam: Change the i.MX8MQ check support all i.MX8M variants
Date
On 12/6/2019 9:55 PM, Adam Ford wrote:
> On Wed, Dec 4, 2019 at 5:38 AM Schrempf Frieder
> <frieder.schrempf@kontron.de> wrote:
>>
>> Hi Adam,
>>
>> On 30.11.19 23:51, Adam Ford wrote:
>>> The i.MX8M Mini uses the same crypto engine as the i.MX8MQ, but
>>> the driver is restricting the check to just the i.MX8MQ.
>>>
>>> This patch lets the driver support all i.MX8M Variants if enabled.
>>>
>>> Signed-off-by: Adam Ford <aford173@gmail.com>
>>
>> What about the following lines in run_descriptor_deco0()? Does this
>> condition also apply to i.MX8MM?
>
> I think that's a question for NXP. I am not seeing that in the NXP
> Linux Release, and I don't have an 8MQ to compare.
>
IIRC the i.MX BSP releases use the JRI for initializing the RNG,
and not the DECO register interface.

> I was able to get the driver working on the i.MXMM with the patch.
>
You are probably using a newer U-boot, which includes
commit dfaec76029f2 ("crypto/fsl: instantiate all rng state handles")

> NXP Team,
>
> Do you have any opinions on this?
>
Since current U-boot initializes both RNG state handles, practically
instantiate_rng() is a no-op.

A simple experiment is to "lie" about the state_handle_mask, to exercise
the DECO acquire code (or, as mentioned above, to run with an older U-boot):

@@ -268,12 +272,19 @@ static int instantiate_rng(struct device *ctrldev, int state_handle_mask,
struct caam_ctrl __iomem *ctrl;
u32 *desc, status = 0, rdsta_val;
int ret = 0, sh_idx;
+ static int force_init = 1;

ctrl = (struct caam_ctrl __iomem *)ctrlpriv->ctrl;
desc = kmalloc(CAAM_CMD_SZ * 7, GFP_KERNEL);
if (!desc)
return -ENOMEM;

+ if (force_init && (state_handle_mask == 0x3)) {
+ dev_err(ctrldev, "Forcing reinit of RNG state handle 0!\n");
+ force_init = 0;
+ state_handle_mask = 0x2;
+ }
+
for (sh_idx = 0; sh_idx < RNG4_MAX_HANDLES; sh_idx++) {
/*
* If the corresponding bit is set, this state handle

In this case boot log confirms the DECO cannot be acquired:
[ 2.137101] caam 30900000.crypto: Forcing reinit of RNG state handle 0!
[ 2.172293] caam 30900000.crypto: failed to acquire DECO 0
[ 2.177786] caam 30900000.crypto: failed to instantiate RNG

To sum up, writing to DECORSR is mandatory.

Horia

\
 
 \ /
  Last update: 2019-12-10 08:56    [W:0.052 / U:0.368 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site