lkml.org 
[lkml]   [2019]   [Nov]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v4 1/3] dt-bindings: sdhci-of-at91: new compatible string and update properties
Date
There is a new compatible string for the SAM9X60 sdhci device. It involves
an update of the properties about the clocks stuff.

Signed-off-by: Ludovic Desroches <ludovic.desroches@microchip.com>
Reviewed-by: Rob Herring <robh@kernel.org>
---

Changes:
- v3: rebase due to conflict with Nicolas' patch
- v2: remove the extra example and fix node label

.../devicetree/bindings/mmc/sdhci-atmel.txt | 13 ++++++++++---
1 file changed, 10 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/mmc/sdhci-atmel.txt b/Documentation/devicetree/bindings/mmc/sdhci-atmel.txt
index 503c6dbac1b2..69edfd4d3922 100644
--- a/Documentation/devicetree/bindings/mmc/sdhci-atmel.txt
+++ b/Documentation/devicetree/bindings/mmc/sdhci-atmel.txt
@@ -5,11 +5,16 @@ Documentation/devicetree/bindings/mmc/mmc.txt and the properties used by the
sdhci-of-at91 driver.

Required properties:
-- compatible: Must be "atmel,sama5d2-sdhci".
+- compatible: Must be "atmel,sama5d2-sdhci" or "microchip,sam9x60-sdhci".
- clocks: Phandlers to the clocks.
-- clock-names: Must be "hclock", "multclk", "baseclk";
+- clock-names: Must be "hclock", "multclk", "baseclk" for
+ "atmel,sama5d2-sdhci".
+ Must be "hclock", "multclk" for "microchip,sam9x60-sdhci".

Optional properties:
+- assigned-clocks: The same with "multclk".
+- assigned-clock-rates The rate of "multclk" in order to not rely on the
+ gck configuration set by previous components.
- microchip,sdcal-inverted: when present, polarity on the SDCAL SoC pin is
inverted. The default polarity for this signal is described in the datasheet.
For instance on SAMA5D2, the pin is usually tied to the GND with a resistor
@@ -17,10 +22,12 @@ Optional properties:

Example:

-sdmmc0: sdio-host@a0000000 {
+mmc0: sdio-host@a0000000 {
compatible = "atmel,sama5d2-sdhci";
reg = <0xa0000000 0x300>;
interrupts = <31 IRQ_TYPE_LEVEL_HIGH 0>;
clocks = <&sdmmc0_hclk>, <&sdmmc0_gclk>, <&main>;
clock-names = "hclock", "multclk", "baseclk";
+ assigned-clocks = <&sdmmc0_gclk>;
+ assigned-clock-rates = <480000000>;
};
--
2.24.0
\
 
 \ /
  Last update: 2019-11-28 08:46    [W:0.086 / U:0.060 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site