lkml.org 
[lkml]   [2019]   [Oct]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 0/3] net: phy: initialize PHYs via device tree properties
Date
I was trying to configure the Atheros PHY for my board. There are fixups
all over the place, for example to enable the 125MHz clock output in almost
any i.MX architecture. Instead of adding another fixup in architecture
specific code, try to provide a generic way to init the PHY registers.

This patch series tries to pick up the "broadcom,reg-init" and
"marvell,reg-init" device tree properties idea and make it a more generic
"reg-init" which is handled by phy_device instead of a particular phy
driver.

Michael Walle (3):
dt-bindings: net: phy: Add reg-init property
net: phy: export __phy_{read|write}_page
net: phy: Use device tree properties to initialize any PHYs

.../devicetree/bindings/net/ethernet-phy.yaml | 31 ++++++
MAINTAINERS | 1 +
drivers/net/phy/phy-core.c | 24 ++++-
drivers/net/phy/phy_device.c | 97 ++++++++++++++++++-
include/dt-bindings/net/phy.h | 18 ++++
include/linux/phy.h | 2 +
6 files changed, 170 insertions(+), 3 deletions(-)
create mode 100644 include/dt-bindings/net/phy.h

Cc: Andrew Lunn <andrew@lunn.ch>
Cc: Florian Fainelli <f.fainelli@gmail.com>
Cc: Heiner Kallweit <hkallweit1@gmail.com>
Cc: "David S. Miller" <davem@davemloft.net>
Cc: Rob Herring <robh+dt@kernel.org>
Cc: Mark Rutland <mark.rutland@arm.com>

--
2.20.1

\
 
 \ /
  Last update: 2019-10-29 18:58    [W:0.081 / U:0.448 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site