lkml.org 
[lkml]   [2019]   [Oct]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] spi: Fix SPI_CS_HIGH setting when using native and GPIO CS
Date
When improving the CS GPIO support at core level, the SPI_CS_HIGH
has been enabled for all the CS lines used for a given SPI controller.

However, the SPI framework allows to have on the same controller native
CS and GPIO CS. The native CS may not support the SPI_CS_HIGH, so they
should not be setup automatically.

With this patch the setting is done only for the CS that will use a
GPIO as CS

Fixes: f3186dd87669 ("spi: Optionally use GPIO descriptors for CS GPIOs")
Cc: <stable@vger.kernel.org>
Signed-off-by: Gregory CLEMENT <gregory.clement@bootlin.com>
---
drivers/spi/spi.c | 18 +++++++++---------
1 file changed, 9 insertions(+), 9 deletions(-)

diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
index 5414a10afd65..1b68acc28c8f 100644
--- a/drivers/spi/spi.c
+++ b/drivers/spi/spi.c
@@ -1880,15 +1880,7 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi,
spi->mode |= SPI_3WIRE;
if (of_property_read_bool(nc, "spi-lsb-first"))
spi->mode |= SPI_LSB_FIRST;
-
- /*
- * For descriptors associated with the device, polarity inversion is
- * handled in the gpiolib, so all chip selects are "active high" in
- * the logical sense, the gpiolib will invert the line if need be.
- */
- if (ctlr->use_gpio_descriptors)
- spi->mode |= SPI_CS_HIGH;
- else if (of_property_read_bool(nc, "spi-cs-high"))
+ if (of_property_read_bool(nc, "spi-cs-high"))
spi->mode |= SPI_CS_HIGH;

/* Device DUAL/QUAD mode */
@@ -1952,6 +1944,14 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi,
}
spi->chip_select = value;

+ /*
+ * For descriptors associated with the device, polarity inversion is
+ * handled in the gpiolib, so all gpio chip selects are "active high"
+ * in the logical sense, the gpiolib will invert the line if need be.
+ */
+ if ((ctlr->use_gpio_descriptors) && ctlr->cs_gpiods[spi->chip_select])
+ spi->mode |= SPI_CS_HIGH;
+
/* Device speed */
rc = of_property_read_u32(nc, "spi-max-frequency", &value);
if (rc) {
--
2.23.0
\
 
 \ /
  Last update: 2019-10-18 17:31    [W:0.075 / U:0.932 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site