lkml.org 
[lkml]   [2019]   [Oct]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 1/3] tty: serial: lpuart: Remove unnecessary code from set_mctrl
Date
Currently flow control is not working due to lpuart32_set_mctrl that is
clearing TXCTSE bit in all cases. This bit gets earlier setup by
lpuart32_set_termios.

As I read in Documentation set_mctrl is also not meant for hardware
flow control rather than gpio setting and clearing a RTS signal.
Therefore I guess it is safe to remove the whole code in
lpuart32_set_mctrl.

This was tested with console on a i.MX8QXP SoC.

Signed-off-by: Philippe Schenker <philippe.schenker@toradex.com>
Reviewed-by: Fugang Duan <fugang.duan@nxp.com>

---

Changes in v2:
- Added Fugang Duan's review

drivers/tty/serial/fsl_lpuart.c | 11 -----------
1 file changed, 11 deletions(-)

diff --git a/drivers/tty/serial/fsl_lpuart.c b/drivers/tty/serial/fsl_lpuart.c
index 537896c4d887..f3271857621c 100644
--- a/drivers/tty/serial/fsl_lpuart.c
+++ b/drivers/tty/serial/fsl_lpuart.c
@@ -1333,18 +1333,7 @@ static void lpuart_set_mctrl(struct uart_port *port, unsigned int mctrl)

static void lpuart32_set_mctrl(struct uart_port *port, unsigned int mctrl)
{
- unsigned long temp;
-
- temp = lpuart32_read(port, UARTMODIR) &
- ~(UARTMODIR_RXRTSE | UARTMODIR_TXCTSE);
-
- if (mctrl & TIOCM_RTS)
- temp |= UARTMODIR_RXRTSE;
-
- if (mctrl & TIOCM_CTS)
- temp |= UARTMODIR_TXCTSE;

- lpuart32_write(port, temp, UARTMODIR);
}

static void lpuart_break_ctl(struct uart_port *port, int break_state)
--
2.23.0
\
 
 \ /
  Last update: 2019-10-17 16:14    [W:0.028 / U:0.544 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site