Messages in this thread Patch in this message | | | From | Veerabhadrarao Badiganti <> | Subject | [PATCH V2 2/3] dt-bindings: mmc: sdhci-msm: Add entries for passing load values | Date | Thu, 20 Sep 2018 11:52:37 +0530 |
| |
From: Vijay Viswanath <vviswana@codeaurora.org>
The load a particular sdhc controller should request from a regulator is device specific and hence each device should individually vote for the required load.
Signed-off-by: Vijay Viswanath <vviswana@codeaurora.org> Signed-off-by: Veerabhadrarao Badiganti <vbadigan@codeaurora.org> --- Documentation/devicetree/bindings/mmc/sdhci-msm.txt | 6 ++++++ 1 file changed, 6 insertions(+)
diff --git a/Documentation/devicetree/bindings/mmc/sdhci-msm.txt b/Documentation/devicetree/bindings/mmc/sdhci-msm.txt index 502b3b8..3720385 100644 --- a/Documentation/devicetree/bindings/mmc/sdhci-msm.txt +++ b/Documentation/devicetree/bindings/mmc/sdhci-msm.txt @@ -26,6 +26,11 @@ Required properties: "cal" - reference clock for RCLK delay calibration (optional) "sleep" - sleep clock for RCLK delay calibration (optional) +Optional properties: +- qcom,<supply>-current-level-microamp - specifies load levels for supply during BUS_ON and + BUS_OFF states in power irq. Should be specified in + pairs (lpm, hpm), for BUS_OFF and BUS_ON respectively. + Units uA. Example: sdhc_1: sdhci@f9824900 { @@ -37,6 +42,7 @@ Example: vmmc-supply = <&pm8941_l20>; vqmmc-supply = <&pm8941_s3>; + qcom,vqmmc-current-level-microamp = <200 22000>; pinctrl-names = "default"; pinctrl-0 = <&sdc1_clk &sdc1_cmd &sdc1_data>; -- Qualcomm India Private Limited, on behalf of Qualcomm Innovation Center, Inc., is a member of Code Aurora Forum, a Linux Foundation Collaborative Project
| |