lkml.org 
[lkml]   [2018]   [Sep]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/3] dmaengine: Add Slave and Cyclic mode support for Actions Semi Owl S900 SoC
On 01-09-18, 22:12, Manivannan Sadhasivam wrote:

> @@ -364,6 +372,26 @@ static inline int owl_dma_cfg_lli(struct owl_dma_vchan *vchan,
> OWL_DMA_MODE_DT_DCU | OWL_DMA_MODE_SAM_INC |
> OWL_DMA_MODE_DAM_INC;
>
> + break;
> + case DMA_MEM_TO_DEV:
> + mode |= OWL_DMA_MODE_TS(vchan->drq)
> + | OWL_DMA_MODE_ST_DCU | OWL_DMA_MODE_DT_DEV
> + | OWL_DMA_MODE_SAM_INC | OWL_DMA_MODE_DAM_CONST;
> +
> + /* Handle bus width for UART */
> + if (sconfig->dst_addr_width == DMA_SLAVE_BUSWIDTH_1_BYTE)
> + mode |= OWL_DMA_MODE_NDDBW_8BIT;

this is fine per se, but not correct way to handle in dmaengine driver.
You should be agnostic to user of dmaengine, so handle all the buswidths
the IP block supports and update the values accordingly. That way new
uses can be added w/o requiring change in dmaengine driver

--
~Vinod

\
 
 \ /
  Last update: 2018-09-18 18:35    [W:0.083 / U:0.348 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site