lkml.org 
[lkml]   [2018]   [Jul]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
SubjectRe: [PATCH v3 4/9] dt-bindings: ata: ahci-platform: document AHCI reset
On Fri, Jul 13, 2018 at 11:03:01AM +0000, Corentin Labbe wrote:
> This patch document the new optional resets for ahci node.
>
> Signed-off-by: Corentin Labbe <clabbe@baylibre.com>
> ---
> Documentation/devicetree/bindings/ata/ahci-platform.txt | 2 ++
> 1 file changed, 2 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/ata/ahci-platform.txt b/Documentation/devicetree/bindings/ata/ahci-platform.txt
> index 5f362af2724c..a5281d7557e3 100644
> --- a/Documentation/devicetree/bindings/ata/ahci-platform.txt
> +++ b/Documentation/devicetree/bindings/ata/ahci-platform.txt
> @@ -34,6 +34,8 @@ Optional properties:
> - phys : reference to the SATA PHY node
> - phy-names : must be "sata-phy"
> - ahci-supply : regulator for AHCI controller
> +- resets : phandle to the reset line of AHCI controller
> + If set, must have a reset-names set as "ahci"

A name is pointless if there is only one. Also, the name should be what
the signal in the block is called which I doubt would be called "ahci".
A likely name is some form of reset, resetn, etc. which again is
pointless to name if there is only 1.

If you do have 'reset-names' then that needs to be listed too like
phy-names.

Rob

\
 
 \ /
  Last update: 2018-07-16 17:54    [W:0.101 / U:0.368 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site