lkml.org 
[lkml]   [2018]   [May]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectB53 DSA switch problem on Banana Pi-R1 on Fedora 26
Date
Hello,

I'm trying to get B53 DSA switch working on the Banana Pi-R1 on Fedora
26 to run (I will upgrade to Fedora 27 and Fedora 28 when networking
works again). Previously the switch was configured with swconfig without
any problems.

Kernel: 4.16.7-100.fc26.armv7hl

b53_common: found switch: BCM53125, rev 4

I see all interfaces: lan1 to lan4 and wan.

i get the following error messages:

# master and self, same results

bridge vlan add dev lan1 vid 101 pvid untagged self
RTNETLINK answers: Operation not supported
bridge vlan add dev lan2 vid 101 pvid untagged self
RTNETLINK answers: Operation not supported
bridge vlan add dev lan3 vid 101 pvid untagged self
RTNETLINK answers: Operation not supported
bridge vlan add dev lan4 vid 101 pvid untagged self
RTNETLINK answers: Operation not supported

# No quite sure here regarding CPU interface and VLAN, because this
changed with some patches, also from dsa.txt

bridge vlan add dev eth0 vid 101 self
RTNETLINK answers: Operation not supported

Planned network structure will be as with 4.7.x kernels:

br0 <=> eth0.101 <=> eth0 (vlan 101 tagged) <=> lan 1-lan4 (vlan 101
untagged pvid)

br1 <=> eth0.102 <=> eth0 (vlan 102 tagged) <=> wan (vlan 102 untagged pvid)

I think the rest of the config is clear after some research now, but I
provide details if that one worked well.

If necessary I can provide full commands & logs and further details.

Thank you.

Any ideas?

Ciao,

Gerhard


\
 
 \ /
  Last update: 2018-05-22 21:24    [W:0.060 / U:0.020 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site