Messages in this thread Patch in this message | | | From | Geert Uytterhoeven <> | Subject | [PATCH] mtd: cmdlinepart: Update comment for introduction of OFFSET_CONTINUOUS | Date | Tue, 22 May 2018 17:07:53 +0200 |
| |
The comment about offset zero was not updated when changing behavior: - Automatic offset calculation is indicated by OFFSET_CONTINUOUS, - Zero really means offset zero.
Fixes: b175d03dd2072836 ("[PATCH] mtd cmdlinepart: allow zero offset value") Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be> --- drivers/mtd/cmdlinepart.c | 5 ++++- 1 file changed, 4 insertions(+), 1 deletion(-)
diff --git a/drivers/mtd/cmdlinepart.c b/drivers/mtd/cmdlinepart.c index fbd5affc0acfe3fe..3ea44cff9b759e3c 100644 --- a/drivers/mtd/cmdlinepart.c +++ b/drivers/mtd/cmdlinepart.c @@ -190,7 +190,10 @@ static struct mtd_partition * newpart(char *s, extra_mem = (unsigned char *)(parts + *num_parts); } - /* enter this partition (offset will be calculated later if it is zero at this point) */ + /* + * enter this partition (offset will be calculated later if it is + * OFFSET_CONTINUOUS at this point) + */ parts[this_part].size = size; parts[this_part].offset = offset; parts[this_part].mask_flags = mask_flags; -- 2.7.4
| |