lkml.org 
[lkml]   [2018]   [May]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] md/raid1: add error handling of read error from FailFast device
On Wed, May 02, 2018 at 01:08:11PM +0200, Gioh Kim wrote:
> Current handle_read_error() function calls fix_read_error()
> only if md device is RW and rdev does not include FailFast flag.
> It does not handle a read error from a RW device including
> FailFast flag.
>
> I am not sure it is intended. But I found that write IO error
> sets rdev faulty. The md module should handle the read IO error and
> write IO error equally. So I think read IO error should set rdev faulty.
>
> Signed-off-by: Gioh Kim <gi-oh.kim@profitbricks.com>
> ---
> drivers/md/raid1.c | 2 ++
> 1 file changed, 2 insertions(+)
>
> diff --git a/drivers/md/raid1.c b/drivers/md/raid1.c
> index e9e3308cb0a7..4445179aa4c8 100644
> --- a/drivers/md/raid1.c
> +++ b/drivers/md/raid1.c
> @@ -2474,6 +2474,8 @@ static void handle_read_error(struct r1conf *conf, struct r1bio *r1_bio)
> fix_read_error(conf, r1_bio->read_disk,
> r1_bio->sector, r1_bio->sectors);
> unfreeze_array(conf);
> + } else if (mddev->ro == 0 && test_bit(FailFast, &rdev->flags)) {
> + md_error(mddev, rdev);
> } else {
> r1_bio->bios[r1_bio->read_disk] = IO_BLOCKED;
> }
> --
> 2.14.1

Looks reasonable, applied!

\
 
 \ /
  Last update: 2018-05-14 21:30    [W:0.047 / U:0.308 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site