Messages in this thread | | | From | Sebastian Reichel <> | Subject | [PATCH 0/2] GE Healthcare PPD firmware upgrade driver for ACHC | Date | Tue, 20 Mar 2018 18:21:59 +0100 |
| |
Hi,
The PPD has a secondary processor from NXP, which can be programmed from the main system. It is connected to the main processor by having it's EzPort interface connected to the SPI bus.
This adds a generic driver to handle firmware flashing via NXP EzPort and adds a custom compatible for the instance found in GE's device. The reset gpio is only requested during flashing, since it is also used for resetting other devices. A better solution for the shared reset gpio is required at some point, but this does neither affect the userspace interface, nor the DT interface and should not block upstreaming this driver.
-- Sebastian
Sebastian Reichel (2): misc: ezport-firmware: new driver ARM: dts: imx53: PPD: Update ACHC programming interface
Documentation/devicetree/bindings/misc/ge-achc.txt | 19 +- arch/arm/boot/dts/imx53-ppd.dts | 5 +- drivers/misc/Kconfig | 9 + drivers/misc/Makefile | 1 + drivers/misc/ezport-firmware.c | 487 +++++++++++++++++++++ 5 files changed, 516 insertions(+), 5 deletions(-) create mode 100644 drivers/misc/ezport-firmware.c
-- 2.16.2
| |