lkml.org 
[lkml]   [2017]   [Oct]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH net] net: stmmac: First Queue must always be in DCB mode
Date
According to DWMAC databook the first queue operating mode
must always be in DCB.

As MTL_QUEUE_DCB = 1, we need to always set the first queue
operating mode to DCB otherwise driver will think that queue
is in AVB mode (because MTL_QUEUE_AVB = 0).

Signed-off-by: Jose Abreu <joabreu@synopsys.com>
Cc: Joao Pinto <jpinto@synopsys.com>
Cc: David S. Miller <davem@davemloft.net>
Cc: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Cc: Alexandre Torgue <alexandre.torgue@st.com>
---
drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c | 7 +++++++
1 file changed, 7 insertions(+)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
index 21f59fe..603225b 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
@@ -150,6 +150,13 @@ static void stmmac_mtl_setup(struct platform_device *pdev,
plat->rx_queues_to_use = 1;
plat->tx_queues_to_use = 1;

+ /* First Queue must always be in DCB mode. As MTL_QUEUE_DCB = 1 we need
+ * to always set this, otherwise Queue will be classified as AVB
+ * (because MTL_QUEUE_AVB = 0).
+ */
+ plat->rx_queues_cfg[0].mode_to_use = MTL_QUEUE_DCB;
+ plat->tx_queues_cfg[0].mode_to_use = MTL_QUEUE_DCB;
+
rx_node = of_parse_phandle(pdev->dev.of_node, "snps,mtl-rx-config", 0);
if (!rx_node)
return;
--
1.9.1

\
 
 \ /
  Last update: 2017-10-26 11:07    [W:0.051 / U:1.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site