lkml.org 
[lkml]   [2016]   [Mar]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 10/12] ARM: dts: dragonboard-600c: Add on board leds support
On Wed, Mar 23, 2016 at 8:48 PM, Srinivas Kandagatla
<srinivas.kandagatla@linaro.org> wrote:
> + led@1 {
> + label = "dragonboard-600c:green:user1";
> + gpios = <&tlmm_pinmux 3 GPIO_ACTIVE_HIGH>;
> + linux,default-trigger = "heartbeat";
> + default-state = "off";
> + };
> +
> + led@2 {
> + label = "dragonboard-600c:green:user2";
> + gpios = <&tlmm_pinmux 7 GPIO_ACTIVE_HIGH>;
> + linux,default-trigger = "mmc0";
> + default-state = "off";
> + };
> +
> + led@3 {
> + label = "dragonboard-600c:green:user3";
> + gpios = <&tlmm_pinmux 10 GPIO_ACTIVE_HIGH>;
> + linux,default-trigger = "mmc1";
> + default-state = "off";
> + };
> +
> + led@4 {
> + label = "apq8016-sbc:green:user4";

typo ^^

> + gpios = <&tlmm_pinmux 11 GPIO_ACTIVE_HIGH>;
> + linux,default-trigger = "none";
> + default-state = "off";
> + };

also, if i read the 96boards specs correctly, the LED are labeled
3-2-1-0 , if you look at the board with the LEDs on the bottom. With
this DT config, you end up with 0-1-2-3 instead.

also, they should be labeled 0 to 3, not 1 to 4.

\
 
 \ /
  Last update: 2016-03-24 18:41    [W:0.163 / U:1.164 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site