lkml.org 
[lkml]   [2015]   [Sep]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] net: stmmac: Use msleep rather then udelay for reset delay
Date
The reset delays used for stmmac are in the order of 10ms to 1 second,
which is far too long for udelay usage, so switch to using msleep.

Practically this fixes the PHY not being reliably detected in some cases
as udelay wouldn't actually delay for long enough to let the phy
reliably be reset.

Signed-off-by: Sjoerd Simons <sjoerd.simons@collabora.co.uk>
---

drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c | 11 ++++++++---
1 file changed, 8 insertions(+), 3 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
index b735fa2..17fa588 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
@@ -161,11 +161,16 @@ int stmmac_mdio_reset(struct mii_bus *bus)

if (!gpio_request(reset_gpio, "mdio-reset")) {
gpio_direction_output(reset_gpio, active_low ? 1 : 0);
- udelay(data->delays[0]);
+ if (data->delays[0])
+ msleep((data->delays[0] + 999) / 1000);
+
gpio_set_value(reset_gpio, active_low ? 0 : 1);
- udelay(data->delays[1]);
+ if (data->delays[1])
+ msleep((data->delays[1] + 999) / 1000);
+
gpio_set_value(reset_gpio, active_low ? 1 : 0);
- udelay(data->delays[2]);
+ if (data->delays[2])
+ msleep((data->delays[2] + 999) / 1000);
}
}
#endif
--
2.5.1


\
 
 \ /
  Last update: 2015-09-06 18:01    [W:0.072 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site