lkml.org 
[lkml]   [2015]   [Sep]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] mmc: core: fix dead loop of mmc_retune
Date
When get a CRC error, start the mmc_retune, it will issue CMD19/CMD21
to do tune, assume there were 10 clock phase need to try, phase 0 to
phase 6 is ok, phase 7 to phase 9 is NG, we try it from 0 to 9, so
the last CMD19/CMD21 will get CRC error, host->need_retune was set and
cause mmc_retune was called, then dead loop of mmc_retune

Signed-off-by: Chaotian Jing <chaotian.jing@mediatek.com>
---
drivers/mmc/core/core.c | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/mmc/core/core.c b/drivers/mmc/core/core.c
index 0520064..a3eb20b 100644
--- a/drivers/mmc/core/core.c
+++ b/drivers/mmc/core/core.c
@@ -134,9 +134,11 @@ void mmc_request_done(struct mmc_host *host, struct mmc_request *mrq)
int err = cmd->error;

/* Flag re-tuning needed on CRC errors */
- if (err == -EILSEQ || (mrq->sbc && mrq->sbc->error == -EILSEQ) ||
+ if ((cmd->opcode != MMC_SEND_TUNING_BLOCK &&
+ cmd->opcode != MMC_SEND_TUNING_BLOCK_HS200) &&
+ (err == -EILSEQ || (mrq->sbc && mrq->sbc->error == -EILSEQ) ||
(mrq->data && mrq->data->error == -EILSEQ) ||
- (mrq->stop && mrq->stop->error == -EILSEQ))
+ (mrq->stop && mrq->stop->error == -EILSEQ)))
mmc_retune_needed(host);

if (err && cmd->retries && mmc_host_is_spi(host)) {
--
1.8.1.1.dirty


\
 
 \ /
  Last update: 2015-09-30 12:01    [W:0.048 / U:0.064 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site