lkml.org 
[lkml]   [2015]   [Sep]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] mmc: sdhci: call sdhci_init() before request irq
Date
sdhci_init() will clear all irqs and set the needed irqs. So
logically sdhci_init() should be called before request irq.

If not, some irqs may be triggled and handled wrongly. Take
the following into consideration, after request irq, if
SDIO card interrupt enabled, a sd card in the sd slot will
trigger a mass of interrupt(SDHCI_INT_CARD_INT), because at
this time, the vmmc-regulator still not restore, no voltage
supply for the sd card, so the pin of data0~data3 change and
keep low, interrupt(SDHCI_INT_CARD_INT) will rise up ceaselessly.
Due to we already reguest irq, system will be busy in handling
this endless irq, can't response to other event.

So we should call sdhci_init() before request irq in sd resume.

Signed-off-by: Haibo Chen <haibo.chen@freescale.com>
---
drivers/mmc/host/sdhci.c | 22 +++++++++++-----------
1 file changed, 11 insertions(+), 11 deletions(-)

diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
index 64b7fdb..6861573 100644
--- a/drivers/mmc/host/sdhci.c
+++ b/drivers/mmc/host/sdhci.c
@@ -2714,17 +2714,6 @@ int sdhci_resume_host(struct sdhci_host *host)
host->ops->enable_dma(host);
}

- if (!device_may_wakeup(mmc_dev(host->mmc))) {
- ret = request_threaded_irq(host->irq, sdhci_irq,
- sdhci_thread_irq, IRQF_SHARED,
- mmc_hostname(host->mmc), host);
- if (ret)
- return ret;
- } else {
- sdhci_disable_irq_wakeups(host);
- disable_irq_wake(host->irq);
- }
-
if ((host->mmc->pm_flags & MMC_PM_KEEP_POWER) &&
(host->quirks2 & SDHCI_QUIRK2_HOST_OFF_CARD_ON)) {
/* Card keeps power but host controller does not */
@@ -2737,6 +2726,17 @@ int sdhci_resume_host(struct sdhci_host *host)
mmiowb();
}

+ if (!device_may_wakeup(mmc_dev(host->mmc))) {
+ ret = request_threaded_irq(host->irq, sdhci_irq,
+ sdhci_thread_irq, IRQF_SHARED,
+ mmc_hostname(host->mmc), host);
+ if (ret)
+ return ret;
+ } else {
+ sdhci_disable_irq_wakeups(host);
+ disable_irq_wake(host->irq);
+ }
+
sdhci_enable_card_detection(host);

return ret;
--
1.9.1


\
 
 \ /
  Last update: 2015-09-15 12:41    [W:0.930 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site