lkml.org 
[lkml]   [2015]   [Jun]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2] drm/msm/hdmi: Use pinctrl in HDMI driver
From
Date

On Tue, 2015-06-02 at 10:12 -0500, "Stéphane Viau" wrote:
> Hi Ivan,
>
> > Hi Stephane,
> >
> > On Mon, 2015-06-01 at 16:28 -0400, Stephane Viau wrote:
> > > Some targets (eg: msm8994) use the pinctrl framework to configure
> > > interface pins. This change adds support for initialization and
> > > pinctrl active/sleep state control for the HDMI driver.
> > >
> > > Signed-off-by: Stephane Viau <sviau@codeaurora.org>
> > > ---
> > > v2:
> > > - Add devicetree binding documentation for pinctrl property [Ivan]
> > > - Use pinctrl framework's PINCTRL_STATE_DEFAULT/SLEEP states [Ivan]
> > >
> >
> > <snip>
> >
> > > static int hdmi_bind(struct device *dev, struct device *master, void
> > > *data)
> > > @@ -365,6 +379,7 @@ static int hdmi_bind(struct device *dev, struct
> > > device *master, void *data)
> > > #ifdef CONFIG_OF
> > > struct device_node *of_node = dev->of_node;
> > > const struct of_device_id *match;
> > > + struct pinctrl *pinctrl;
> > >
> > > match = of_match_node(dt_match, of_node);
> > > if (match && match->data) {
> > > @@ -383,6 +398,18 @@ static int hdmi_bind(struct device *dev, struct
> > > device *master, void *data)
> > > hdmi_cfg->mux_sel_gpio = get_gpio(dev, of_node,
> > > "qcom,hdmi-tx-mux-sel");
> > > hdmi_cfg->mux_lpm_gpio = get_gpio(dev, of_node,
> > > "qcom,hdmi-tx-mux-lpm");
> > >
> > > + /* not all targets have pinctrl, do not fail in case of error:
> > > */
> > > + pinctrl = devm_pinctrl_get(dev);
> >
> > Probably I have to be more explicit. Why not using pins binding handled in
> > driver
> > really_probe()? I have to admit that I am not familiar with DRM subsystem.
>
> This would work, indeed, for default/sleep/idle states.
>
> I actually had in mind that we'd need to keep track of HDMI pinctrl states
> because we may need to add a couple more in the near future in order to
> independently enable/disable certain parts of the HDMI controller (eg:
> HPD, DDC, CEC..).
>
> Each of this HW sub-sections of the controller are driven by a different
> "pin" in the downstream driver... But since this is nowhere close to being
> upstream-ed yet, I'll go ahead with your idea of using the common pins
> binding (v3 to follow).

v3? Why we need a patch if we already have required support?

Regards,
Ivan



\
 
 \ /
  Last update: 2015-06-02 18:01    [W:0.059 / U:0.112 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site