lkml.org 
[lkml]   [2015]   [Jun]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2] spi: img-spfi: Same Edge bit set to double supported transfer speed
Date
Same edge bit set in SPFI Control register to double the supported
spfi clock speed. Setting this bit increases the supported spfi
frequency from 1/8 to 1/4 of the core clock frequency.

Without this bit set the maximum speed supported was 25MHz on
Pistachio.

Change-Id: I26782ea88ac3567e72dac11e46c5b5f5f52c5e3d
Signed-off-by: Sifan Naeem <sifan.naeem@imgtec.com>
---
drivers/spi/spi-img-spfi.c | 2 ++
1 file changed, 2 insertions(+)

diff --git a/drivers/spi/spi-img-spfi.c b/drivers/spi/spi-img-spfi.c
index 788e2b1..acce90a 100644
--- a/drivers/spi/spi-img-spfi.c
+++ b/drivers/spi/spi-img-spfi.c
@@ -40,6 +40,7 @@
#define SPFI_CONTROL_SOFT_RESET BIT(11)
#define SPFI_CONTROL_SEND_DMA BIT(10)
#define SPFI_CONTROL_GET_DMA BIT(9)
+#define SPFI_CONTROL_SE BIT(8)
#define SPFI_CONTROL_TMODE_SHIFT 5
#define SPFI_CONTROL_TMODE_MASK 0x7
#define SPFI_CONTROL_TMODE_SINGLE 0
@@ -491,6 +492,7 @@ static void img_spfi_config(struct spi_master *master, struct spi_device *spi,
else if (xfer->tx_nbits == SPI_NBITS_QUAD &&
xfer->rx_nbits == SPI_NBITS_QUAD)
val |= SPFI_CONTROL_TMODE_QUAD << SPFI_CONTROL_TMODE_SHIFT;
+ val |= SPFI_CONTROL_SE;
spfi_writel(spfi, val, SPFI_CONTROL);
}

--
1.7.9.5


\
 
 \ /
  Last update: 2015-06-17 12:21    [W:0.050 / U:1.688 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site