lkml.org 
[lkml]   [2015]   [May]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH net-next 1/1] hv_netvsc: Properly size the vrss queues
Date


> -----Original Message-----
> From: David Miller [mailto:davem@davemloft.net]
> Sent: Wednesday, May 27, 2015 11:13 AM
> To: KY Srinivasan
> Cc: netdev@vger.kernel.org; linux-kernel@vger.kernel.org;
> devel@linuxdriverproject.org; olaf@aepfle.de; apw@canonical.com;
> jasowang@redhat.com
> Subject: Re: [PATCH net-next 1/1] hv_netvsc: Properly size the vrss queues
>
> From: "K. Y. Srinivasan" <kys@microsoft.com>
> Date: Tue, 26 May 2015 16:21:09 -0700
>
> > The current algorithm for deciding on the number of VRSS channels is
> > not optimal since we open up the min of number of CPUs online and the
> > number of VRSS channels the host is offering. So on a 32 VCPU guest
> > we could potentially open 32 VRSS subchannels. Experimentation has
> > shown that it is best to limit the number of VRSS channels to the number
> > of CPUs within a NUMA node. As part of this work introduce a module
> > parameter to control the number of sub-channels we would open up as
> well.
> > Here is the new algorithm for deciding on the number of sub-channels we
> > would open up:
> > 1) Pick the minimum of what the host is offering and what the driver
> > in the guest is specifying via the module parameter.
> > 2) Pick the minimum of (1) and the numbers of CPUs in the NUMA
> > node the primary channel is bound to.
> >
> > Signed-off-by: K. Y. Srinivasan <kys@microsoft.com>
>
> No new module parameters, sorry.
>
> You will have to make it such that this can be changed at run time,
> and use a generic run-time mechanism to configure this value that any
> driver can use.
>
> I will not accept: "this is not possible" or "this is too hard" as a
> reason why you have to use a module parameter.
>
> Settings that cannot be set at run time are painful for people who run
> large scale operations where resetting entire systems to change a
> setting is completely and utterly impractical.

Agreed; we are working on full ethtool support to address this very issue. The
module parameter that I introduced here was just a temporary solution until
the full ethtool support. I will get rid of the module parameter and resubmit this patch.

Regards,

K. Y


\
 
 \ /
  Last update: 2015-05-27 21:01    [W:0.913 / U:25.724 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site