lkml.org 
[lkml]   [2015]   [Mar]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] Documentation: usb: serial: fixed how to provide vendor and product id
Date
From: "H. Nikolaus Schaller" <hns@goldelico.com>

While trying to test the Pyra GSM/GPS/3G module I had reconfigured
the USB interface by mistake and therefore needed to run a different
USB driver than CSC-ACM. It turned out that I need the "usbserial" driver.

This file is an official description how to use it:
Documentation/usb/usb-serial.txt

But it is outdated. The parameters vendor= and product= are no longer
available since ca. 3.12 which means that documentation is lagging behind
quite some time.

Here was the solution:

https://bbs.archlinux.org/viewtopic.php?id=175499

insmod usbserial vendor=0x#### product=0x####

becomes (first #### is vendor, second is product)

modprobe usbserial
echo #### #### >/sys/bus/usb-serial/drivers/generic/new_id

This patch changes the documentation file as needed.

Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com>
---
Documentation/usb/usb-serial.txt | 12 +++++++-----
1 file changed, 7 insertions(+), 5 deletions(-)

diff --git a/Documentation/usb/usb-serial.txt b/Documentation/usb/usb-serial.txt
index 947fa62..9f184d8 100644
--- a/Documentation/usb/usb-serial.txt
+++ b/Documentation/usb/usb-serial.txt
@@ -466,11 +466,13 @@ Generic Serial driver
is required of your device is that it has at least one bulk in endpoint,
or one bulk out endpoint.

- To enable the generic driver to recognize your device, build the driver
- as a module and load it by the following invocation:
- insmod usbserial vendor=0x#### product=0x####
- where the #### is replaced with the hex representation of your device's
- vendor id and product id.
+ To enable the generic driver to recognize your device, configure
+ USB_SERIAL_GENERIC=y and build the driver as a module. Then load it by the
+ following invocation:
+ modprobe usbserial
+ echo #### #### >/sys/bus/usb-serial/drivers/generic/new_id
+ where the the first #### is replaced with the hex representation of your
+ device's vendor id and the second #### by the product id.

This driver has been successfully used to connect to the NetChip USB
development board, providing a way to develop USB firmware without
--
1.9.1


\
 
 \ /
  Last update: 2015-03-25 22:01    [W:0.095 / U:0.724 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site