lkml.org 
[lkml]   [2015]   [Mar]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 3/3] mtd: nand: Wire up on-die ECC support
Date
Finally add the Kconfig stuff for on-die ECC support
such that the feature can be enabled.

Signed-off-by: Richard Weinberger <richard@nod.at>
---
drivers/mtd/nand/Kconfig | 12 ++++++++++++
drivers/mtd/nand/Makefile | 1 +
2 files changed, 13 insertions(+)

diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
index 5897d8d..215f74e 100644
--- a/drivers/mtd/nand/Kconfig
+++ b/drivers/mtd/nand/Kconfig
@@ -37,6 +37,18 @@ config MTD_NAND_ECC_BCH
ECC codes. They are used with NAND devices requiring more than 1 bit
of error correction.

+config MTD_NAND_ECC_ON_DIE
+ bool "Support Micron On-Die ECC"
+ default n
+ help
+ Some Micron chips have an internal (on-die) ECC-controller that is
+ useful when the host-platform doesn't have hardware-support for
+ multi-bit ECC and software ECC consumes too much CPU cycles.
+ This enables support for this ECC mode.
+ Please consult your NAND chip's datasheet if you want to use
+ on-die ECC, it is likely that you'll have to adjust some timing
+ settings in your board setup.
+
config MTD_SM_COMMON
tristate
default n
diff --git a/drivers/mtd/nand/Makefile b/drivers/mtd/nand/Makefile
index 582bbd05..44e952cc 100644
--- a/drivers/mtd/nand/Makefile
+++ b/drivers/mtd/nand/Makefile
@@ -5,6 +5,7 @@
obj-$(CONFIG_MTD_NAND) += nand.o
obj-$(CONFIG_MTD_NAND_ECC) += nand_ecc.o
obj-$(CONFIG_MTD_NAND_BCH) += nand_bch.o
+obj-$(CONFIG_MTD_NAND_ECC_ON_DIE) += nand_ondie.o
obj-$(CONFIG_MTD_NAND_IDS) += nand_ids.o
obj-$(CONFIG_MTD_SM_COMMON) += sm_common.o

--
2.3.4


\
 
 \ /
  Last update: 2015-03-25 16:01    [W:0.448 / U:0.900 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site